Home

Home / DELL / D-XTR-MN-A-24

Question list

List of questions

Question 1

(0)

What must be submitted with an RPQ prior to a dispersed XtremlO cluster installation?

Question 2

(0)

Which ports need to be open between the XMS and X1-SC1 to successfully operate Technician Advisor on an XtremIO X2?

Question 3

(0)

Into which directory must the XtremApp software be copied on the XMS?

Question 4

(0)

Where can the XtremlO power requirements be found?

Question 5

(0)

Which document should be referenced when modifying the IP addresses on an XtremIO X2 cluster that will remain in the same IP network?

Question 6

(0)

Which type of InfiniBand switch is used in a multi-brick XtremIO X2-R array?

Question 7

(0)

Why is an extra rack unit space used between X-Bricks when installing a multi X-Brick XtremIO X2?

Question 8

(0)

DRAG DROP From bottom to top, what is the correct racking order of the first four components to expand an XtremlO X1 configuration from a dual X-Brick to a quad X-Brick?

Question 9

(0)

In an XtremIO X2, what is the maximum number of lifetime cycles for NVRAM?

Question 10

(0)

When comparing XtremlO X1 to XtremlO X2, how much memory is installed in a Storage Controller that has a DAE attached with 400 GB SSDs?

Open VPLUS File

Convert VPLUS to PDF

Related questions

What is the impact of a serial cable failure in a multi X-Brick XtremIO X1 cluster?

When preparing for a single-to-dual online cluster expansion, which power cables are pre-staged by being connected to PDU-B only?

How much rack space is required for a four X-Brick XtremIO X2 cluster with a physical XMS?

After changing the IP addresses of the Storage Controllers, which XMCLI command is used to verify that those addresses are correct?

What is an acceptable SSD configuration for an XtremIO X1 cluster?

What is the SAS connection speed on an XtremIO X1 compared to an X2?

On an XtremlO X2-S, which ports are used on the InfiniBand switches for an ISL connection?

Which command is used to verify the ESRS configuration?

In which download section on support.emc.com can the virtual XMS OVA be found?

Which firewall ports need to be opened for an XtremlO cluster to use FTPS for Connect Home?

Question 4 - D-XTR-MN-A-24 discussion

Report

Where can the XtremlO power requirements be found?

A.

XtremIO Storage Array Software Installation and Upgrade Guide

B.

XtremIO Storage Array Hardware Installation and Upgrade Guide

C.

XtremIO Storage Array Site Preparation Guide

D.

XtremIO Storage Array Pre-Installation Checklist

Show Answer

asked 16/09/2024

Emmanuel Yeboah

38 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first