ExamGecko
Search Search Login
Home Home / Fortinet / NSE6_FSW-7.2
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibits. You are asked to ensure that managed FortiSwitch devices are reachable by other devices, such as SNMP and other management tools across your network. Which setting must you configure to ensure traffic from other devices in the network reaches FortiSwitch?
Refer to the exhibit. Core-1 and Access-1 are managed and authorized by FortiGate-1. which uses port4 as the FortiLink interface. After FortiGate authorizes and manages Core-2. Port1 status becomes STP discarding. Why is port1 in the discarding state?
Which feature should you enable to reduce the number or unwanted IGMP reports processed by the IGMP querier?
Exhibit. The exhibit shows the current status of the ports on the managed FortiSwitch. Access-1. Why would FortiGate display a serial number in the Native VLAN column associated with the port23 entry?
Exhibit. Two routes are not installed in the forwarding information base (FIB) as shown in the exnibit. Which two statements about these two route entries are true? (Choose two.)
Exhibit. port24 is the only uplink port connected to the network where access to FortiSwitch management services is possible. However, FortiSwitch is still not accessible on the management interface. Which two actions should you take to fix the issue and access FortiSwitch? (Choose two.)
Which two rules used by MSTP are similar to rules used by other STP methods? (Choose two.)
Which Ethernet frame can create Layer 2 flooding due to all bytes on the destination MAC address being set to all FF?
What feature can network administrators use to segment network operations and the administration of managed FortiSwitch devices on FortiGate?
Which two types of Layer 3 interfaces can participate in dynamic routing on FortiSwitch? (Choose two.)

Question 50 - NSE6_FSW-7.2 discussion

Report
Export

Exhibit.

You need to manage three FortiSwitch devices using a FortiGate device. Two of the FortiSwitch devices initiated a reboot after the authorization process. However, the FortiSwitch device with the configuration shown in the exhibit. did not reboot All three devices completed FortiLink manage-ment authorization successfully.

Why did the FortiSwitch device shown in the exhibit not reboot to complete the authorization pro-cess?

The management mode was set to use FortiLink mode.

A.
Switch auto-discovery is enabled.
Answers
A.
Switch auto-discovery is enabled.
B.
The management mode was set to use FortiLink mode.
Answers
B.
The management mode was set to use FortiLink mode.
C.
The FortiSwitch device is scheduled to reboot as part the authorization process
Answers
C.
The FortiSwitch device is scheduled to reboot as part the authorization process
D.
The system time is not in-sync and is using a non-default value
Answers
D.
The system time is not in-sync and is using a non-default value
Suggested answer: B
Show Answer
asked 18/09/2024
Francisli Lilles
42 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms