Home

Home / Huawei / H12-224

Question list

List of questions

Question 1

(0)

Which statements about QinQ are true? (Choose two.)

Question 2

(0)

Which statement about port isolation configuration is false?

Question 3

(0)

Which statements about MUX VLAN are true? (Choose two.)

Question 4

(0)

As shown in the figure, when the link between SWC and LAND is faulty, through which path are TCA BPDUs sent?

Question 5

(0)

Two switches are directly connected to each other and they are working in full duplex mode. By default, RSTP will consider the link between the switches as point-to-point link.

Question 6

(0)

On the RSTP network with STP devices, which packets does an RSTP switch use to notify the STP switches of the topology change?

Question 7

(0)

If the customer requires high mobility and easy management, the staff of different departments can be added to different VLANs. In addition, these VLANs are located on different IP subnets. Which VL

Question 8

(0)

Which statement about the trunk interface is true?

Question 9

(0)

In RSTP, the port status can be discarding and learning. Which statements about the port status are true? (Choose two.)

Question 10

(0)

Which statements about VLAN aggregation are true? (Choose three.)

Open VPLUS File

Convert VPLUS to PDF

Related questions

As shown in the figure, when the link between SWC and LAND is faulty, through which path are TCA BPDUs sent?

What is the default priority of the device in a VRRP group?

Which interface is connected to the user-side interface?

Configuring a firewall to work in transparent mode does not change the network topology.

According to OSI reference model, Layer 2 LAN switch operates at ( ).

Which statements about MUX VLAN are true? (Choose two.)

Which of the following statements regarding the transit node in the MPLS forwarding process is correct?

Dividing a network using VLANs can (). (Choose two.)

If the customer requires high mobility and easy management, the staff of different departments can be added to different VLANs. In addition, these VLANs are located on different IP subnets. Which VLAN allocation mode can meet these requirements?

On the RSTP network with STP devices, which packets does an RSTP switch use to notify the STP switches of the topology change?

Question 2 - H12-224 discussion

Report

Which statement about port isolation configuration is false?

A.

Port isolation can be used for Layer 2 isolation.

B.

In port isolation mode, ports are isolated at Layer 2 but can communicate at Layer 3 by default.

C.

Before the port isolation function takes effect on an interface, the port isolation function must be enabled first.

D.

The port-isolate enable command can run in the system view.

Show Answer

asked 18/09/2024

Eduardo Rives

40 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first