Home / Huawei / H12-811_V1.0

Question list

List of questions

Question 1

(0)

The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question) <Huawei>display mac address MAC address table of

Question 2

(0)

In the broadcast network as shown in the figure, 0SPF runs on four routers. And in the same are a. The same network segment. SPF will automatically elect one DR and multiple BDRs to achieve a better

Question 3

(0)

As shown in the figure below. Which network device can host A and host B use to achieve communication? () (Single-choice question)

Question 4

(0)

The network shown in the figure below. The router receives a data packet with a destination IP address of 11.0.12.1 from host A. After this data is forwarded by the router, what are the destination

Question 5

(0)

The network structure and OSPF partition are shown in the figure. Except for RTA in the figure, the routers RTB, RTC and RTD are all ABR routers. ()(True or False)

Question 6

(0)

In the network shown in the figure below, when the 0$PF neighbor status is stable. What is the neighbor status of Router B and Router C?

Question 7

(0)

In the network shown in the figure below, switch A and router A are connected by two links, and the two links are aggregated in manual load sharing mode. The aggregated port number is 1, and the agg

Question 8

(0)

The output information of the STP port of a certain switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question) [Huawei]display stp interface Ethernet 0/0

Question 9

(0)

Telnet is a module that implements the Telnet protocol that comes with Python ()

Question 10

(0)

Using the command mkdirtest in the VRP operating platform, the system will create a directory named test. ()

Question 66 - H12-811_V1.0 discussion

The topology shown in the figure and the configuration on the interconnection ports of the switch. Can it be judged that the data frame tagged as VLAN10 can be forwarded normally between the two switches? ()(True or False)

(LSW1) interface GigabitEthernet 0/0/1

(LSW1-GigabitEthernet0/0/1) port link-type trunk

(LSW1-GigabitEthernet0/0/1) port trunk pvid vlan 20

(LSW1-GigabitEthernet0/0/1) port trunk allow-passvlan 10

(LSW2) interface GigabitEthernet 0/0/1

(LSW2-GigabitEthernet0/0/1) port link-type trunk

(LSW2-GigabitEthernet0/0/1 port trunk pvid vlan 10

(LSW2-GigabitEthernet0/0/1) port trunk allow-passvlan 10

True

False

Show Answer

asked 18/09/2024

Ivan Mazala

43 questions

Your answer: A B

0 comments

Sorted by