ExamGecko
Search Search Login
Home Home / Huawei / H12-811_V1.0
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

If host A has the ARP cache of host B. , host A. can ping host B. ()
Which of the following descriptions about the switch is wrong?
SNMP packets are transmitted by UDP.
Only the WPA2-PSK security policy supports TKIP data encryption.
On the network shown in the following figure, assuming that SWA, SWB, and SWC retain factory defaults, which of the following ports will be selected as a designated port?
The administrator made the configuration on the router as shown in the figure. At the same time, the administrator wants to assign a shorter lease period to the DHCP address. Which of the following commands should be used? () (Single-choice question) ip pool pooll netyork10.10.10.0ask255.255.255.0 gateway-list 10.10.10.1
In the VRP interface, use the command startup saved-configuration backup.cfg. Configure the startup.cfg file to be used at the next startup ()
The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? () interface GigabitEthernet0/0/1 port link type trunk port trunk pviD. vlan 200 port trunk allow-pass vlan100#
The switch GE0/0/1 port configuration information is shown in the figure. Which VLAN data frame does the switch not carry when forwarding?()
When the FIT AP goes online, the software version will be downloaded from AC.

Question 623 - H12-811_V1.0 discussion

Report
Export

The output information of a certain device is shown in the figure. Which of the following statements is correct? ( )

display interface G1gabitEthernet 0/0/0 G1 gabi tEthernet0/0/0 currentstate UP Line protocol current state UP Route Port,The Maximum Transmit Unit is 1000 Internet Address is 10.0.12.2/24 IP Sending Frames'Format is PRTFMT ETENT 2.Hardware address is 00e0-fc22-4fff Port Mode:FORCE COPPER SpeeD. :100, Loopback:NONE Duplex:FULL, Negotiation:DISABLE Md1 AUTO Last 300 seconds input rate 24 bits/seC. 0 packets/sec Last 300 seconds output rate 24 bits /seC. 0 packets/seC. *

A.
The P address of the interface is 10.0.12.2/24
Answers
A.
The P address of the interface is 10.0.12.2/24
B.
The MAC of the interface. The address is 00e0-fc22-4fff
Answers
B.
The MAC of the interface. The address is 00e0-fc22-4fff
C.
The working rate of this interface is 1Gbps
Answers
C.
The working rate of this interface is 1Gbps
D.
The MTU value of this interface is 1000
Answers
D.
The MTU value of this interface is 1000
Suggested answer: A, B, D
Show Answer
asked 18/09/2024
Jesus De Leon Luis
47 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms