Home / Huawei / H35-260

Question list

List of questions

Question 1

(0)

According to the IEEE 802JQ standard, where is the VLAN ID field on the Ethernet?

Question 2

(0)

What are the reasons for the R-Los alarm reported on the 0TU board?

Question 3

(0)

Which of the following light source technologies does the 100GOTU board use?

Question 4

(0)

The 802.1Q tag header contains a two-byte TPID. Which of the following is its standard value?

Question 5

(0)

Both the 1310nm and 1550nm transmission windows are low-loss windows. In the DWDM system, only the 1550nm transmission window is used. Which of the following options is the main reason?

Question 6

(0)

Which of the following alarms will be reported by the peer end when it is detected that the error code exceeds the limit in the B2 byte?

Question 7

(0)

In the CES service, which of the descriptions of "packet loading time" and "jitter buffer time" is wrong?

Question 8

(0)

DCM optical power debugging requires the input of DCM to be no greater than which of the following values?

Question 9

(0)

The DWDM system has extremely high requirements on the stability of the light source. Which of the following factors will affect the stability of the light source?

Question 10

(0)

The EDFA erbium-doped fiber amplifier is a key component of the new generation of optical fiber systems. Which of the following options are correct for the description of its advantages?

Question 114 - H35-260 discussion

Which of the following statements about multiplexed partial range error indication (MS-REI) is true ?

① B2 byte represents the transmission channel.

② M1 byte folder indicates the transmission channel

③ MS-REI is sent from the receiver to the source.

④ MS-REI is transmitted from source to receiver

⑤ Indicates the number of bit errors detected by the receiver after receiving the MS signal.

①④⑤

②④⑤

①③⑤

②③⑤

Show Answer

asked 18/09/2024

HASEEB IMTIAZ

33 questions

Your answer: A B C D

0 comments

Sorted by