Home

Home / Huawei / H35-460

Question list

List of questions

Question 1

(0)

3GPP Release Version 15 does not describe which 5G application scenario?

Question 2

(0)

What is IMT-2020's vision for peak rates for 5G networks?

Question 3

(0)

Compared with 4G, 5G redefines the core network NGC, which network elements are mainly included? (multiple selection).

Question 4

(0)

Which of the following 5C network evolution paths has the lowest deployment cost?

Question 5

(0)

Which of the following bands is not included in the candidate SUL spectrum for uplink and downlink decoupling in the C-band?

Question 6

(0)

In the Sub 3G band, the maximum number of SSBs in NR is 16.

Question 7

(0)

In the Sub 6G band, what is the maximum beam number of 5G SSB?

Question 8

(0)

Regarding the DMRS of the PDSCH, what are the correct descriptions of the following? (Multiple Choice)

Question 9

(0)

What is the length of the TTI scheduled in the 5G NR?

Question 10

(0)

Where is the downlink data distribution in the NSA architecture implemented?

Open VPLUS File

Convert VPLUS to PDF

Related questions

gNodeB binds the operator ID when adding tracking area information.

What is the MML command used by gNodeB to add CI port configuration?

Which is the choice of clock synchronization mode for C-Band low-frequency networking gNodeB base station?

In the Sub 3G band, the maximum number of wave speeds for SSBs in NR is 16.

When port negotiation for a X2 interface SCTP link, the local and peer can share the same port number.

Before using U2020 remote NR base station commissioning, which of the following tasks must be prepared?

What is the fiber pulling capacity between AAU and BBU using eCPRI schemes

Which of the following models of fan boards can be adapted to the BBU5900?

Which of the following RF units operates in the 1800Mhz band and meets the needs of uplink and downlink decoupling applications?

Which MML command is used to add MCC and MNC information to gNodeB?

Question 113 - H35-460 discussion

Report

Which MML command is used to add MCC and MNC information to gNodeB?

A.

ADD OPERATOR

B.

ADD GNBOPERATOR

C.

ADD CNOPERATOR

D.

ADD NROPERATOR

Show Answer

asked 18/09/2024

Balazs Jarmy

48 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first