ExamGecko
Search Search Login
Home Home / VCE / 210-015
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

You are implementing 32 new UCS B230 M3 blades into an existing Vblock System with 16 blades. After powering the new blades on, and migrating them to the Cisco Nexus 1000V, you notice that half of the new blades no longer respond to any network traffic. What is the cause?
You power on a Vblock System 320 and look at the Maps tab of an ESXi server in vCenter's Hosts And Clusters view and see an ESXi server with a red "x" over it. What is causing the ESX server problem?
A VM on the Vblock System 320 is unable to communicate on the customer network. When examining the virtual machine, you notice it has the same port group as the other VMs on the same ESXi server. Which action must you perform to resolve the problem?
Which database platform is supported with VMware 5.x in a Vblock System?
While upgrading five hosts in a vSphere cluster, the maintenance window ends. The customer does not allow you to extend the window, so now the cluster is running the hosts at different build levels. There are two hosts at the new build version, and three hosts at the previous build version. There are 11 virtual machines protected by VMware Fault Tolerance in the cluster. You now see the following error No suitable host can be found to place the Fault Tolerance Secondary VM for virtual machine SalesVM. What is the cause of this error?
The ESXi 5.0 servers appear to have hardware problems after you have powered up the Vblock System 320. You want to view the log files for the ESXi servers. What are two ways to accomplish this task? (Choose two.)
During the deployment of a Vblock System, it was discovered that the Cisco Nexus 1000V VSM virtual machines were residing upon the same vSphere host in the AMP. To comply with VCE best practices for separating the Cisco Nexus 1000V VSM virtual machines, what is missing?
Which two methods would you use to deploy an ESXi image created with Image Builder CLI? (Choose two.)
In a standard Vblock System 300 configuration with two vHBAs, the VNX Storage Processor A (SP-A) has rebooted. How will the hosts be impacted?
You want to configure vMotion on a virtual switch in a Vblock System 320. Which network configuration is required?

Question 20 - 210-015 discussion

Report
Export

A new VLAN has been configured on your Nexus 1000V for VM data traffic on VLAN 202 using the following commands.

vlan 202

name datavlan-202

port-profile type vethernet VM-DATA-202

vmware port-group

switchport mode access

switchport access vlan 202

no shutdown

max-ports 512

state enabled

After deploying a virtual machine on the new VLAN, connectivity outside of this network does not appear to work.

Which action will resolve the problem?

A.
Apply the system VLAN attribute.
Answers
A.
Apply the system VLAN attribute.
B.
Use the switchport mode trunk command.
Answers
B.
Use the switchport mode trunk command.
C.
Add VLAN to the uplink port-profile configuration.
Answers
C.
Add VLAN to the uplink port-profile configuration.
D.
Increase default port count.
Answers
D.
Increase default port count.
Suggested answer: C
Show Answer
asked 23/09/2024
David Ezejimofor
36 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms