Home / Network Appliance / NS0-520

Question list

List of questions

Question 1

(0)

You are asked to serve iSCSI LUNs in an existing SVM on your AFF A220 using ONTAP 9.5. You verified that the iSCSI license is configured on your cluster and that the iSCSI protocol is enabled. Re

Question 2

(0)

You are testing iSCSI LUN failover across a 4-node FAS9000 fabric-attached MetroCluster configuration. In this scenario, which front end configuration is required for non-disruptive host LUN failov

Question 3

(0)

Referring to the exhibit, which two pairs of ports are currently configurable as FC SAN LIFs? (Choose two.)

Question 4

(0)

You have a 4-node cluster with an AFF A300 HA pair and a FAS8200 HA pair. You plan on using the default storage efficiency settings. With inline data compaction, you estimate that you can save 6% of

Question 5

(0)

You have a requirement to serve LUNs with under 200 microsecond latency using local server lass memory. You also are required to use a shared SAN. Using MAX Data as shown in the exhibit, which tw

Question 6

(0)

A company has 20 ESX hosts. Ten of the hosts are connected using FC, and the rest are connected over iSCSI. The FC host HBA queue depth is set to 32, and the iSCSI LUN queue depth is set to 64. The

Question 7

(0)

You want to ensure maximum performance of iSCSI LUNs on an AFF A220. In this scenario, which two actions will accomplish this task? (Choose two.)

Question 8

(0)

You are provisioning storage to an ESX host that uses iSCSI. According to NetApp best practice, which three actions accomplish this task? (Choose three.)

Question 9

(0)

A customer has an AFF A700 connected to a Cisco switch and has verified connectivity but cannot see any LUNs. The customer issued the run -node scaling-01 -command fcp topology show command to ver

Question 10

(0)

A customer is using both FC and NVMe in a cluster. The customer needs to do some work on AFF_1. Referring to the exhibit, what will happen?

Question 166 - NS0-520 discussion

When running diagnostic tests after an initial installation of a NetApp FAS3000 storage system, which command is used to run a comprehensive set of diagnostic tests on the entire system?

all

comprehensive

full

stress

Show Answer

asked 23/09/2024

FARIZA MANNAN

39 questions

Your answer: A B C D

0 comments

Sorted by