Home / VMware / 2V0-41.20

Question list

List of questions

Question 1

(0)

An NSX administrator noticed that the nsxcli command times out after 600 secs of idle time. Which CLI command disables the nsxcli time out value on NSX Manager?

Question 2

(0)

An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy. Which profile allows the administrator to configure th

Question 3

(0)

Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.)

Question 4

(0)

Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?

Question 5

(0)

Which three steps are required to create an IPsec VPN tunnel? (Choose three.)

Question 6

(0)

An NSX administrator wants to create a Tier-0 Gateway to support equal cost multi-path (ECMP) routing. Which failover detection protocol must be used to meet this requirement?

Question 7

(0)

What are two supported N-VDS modes? (Choose two.)

Question 8

(0)

A user is assigned these two roles in NSX Manager: LB Admin Network Engineer What privileges does this user have in the system?

Question 9

(0)

An NSX administrator has configured a KVM hypervisor as a transport node. Which kernel module on KVM implements a N-VDS?

Question 10

(0)

Which CLI command should be executed on a KVM hypervisor to retrieve the VM interface UUID?

Question 1 - 2V0-41.20 discussion

An NSX administrator noticed that the nsxcli command times out after 600 secs of idle time.

Which CLI command disables the nsxcli time out value on NSX Manager?

set cli-timeout 0

set cli-timeout enabled

set cli-timeout disabled

set cli-timeout 1

Show Answer

asked 16/09/2024

Carole Pie

46 questions

Your answer: A B C D

0 comments

Sorted by