Home

Home / VMware / 2V0-41.20

Question list

List of questions

Question 1

(0)

An NSX administrator noticed that the nsxcli command times out after 600 secs of idle time. Which CLI command disables the nsxcli time out value on NSX Manager?

Question 2

(0)

An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy. Which profile allows the administrator to configure th

Question 3

(0)

Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.)

Question 4

(0)

Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?

Question 5

(0)

Which three steps are required to create an IPsec VPN tunnel? (Choose three.)

Question 6

(0)

An NSX administrator wants to create a Tier-0 Gateway to support equal cost multi-path (ECMP) routing. Which failover detection protocol must be used to meet this requirement?

Question 7

(0)

What are two supported N-VDS modes? (Choose two.)

Question 8

(0)

A user is assigned these two roles in NSX Manager: LB Admin Network Engineer What privileges does this user have in the system?

Question 9

(0)

An NSX administrator has configured a KVM hypervisor as a transport node. Which kernel module on KVM implements a N-VDS?

Question 10

(0)

Which CLI command should be executed on a KVM hypervisor to retrieve the VM interface UUID?

Open VPLUS File

Convert VPLUS to PDF

Related questions

What are three characteristics of a transport zone? (Choose three.)

An NSX administrator is troubleshooting a connectivity issue with virtual machines running on an ESXi transport node. Which feature in the NSX UI shows the mapping between the virtual NIC and the host's physical adapter?

An NSX administrator is planning to deploy a multi-tier routing topology in their NSX-T Data Center environment to provide north-south connectivity for the VMs. Which routing component must be deployed?

An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmission unit size on the physical switch is 1600. Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?

Which two statements are true about the implementation of multicast in NSX-T Data Center? (Choose two.)

An administrator has a requirement to have consistent policy configuration and enforcement across NSXT instances. What feature of NSX-T Data Center fulfills this requirement?

An NSX administrator has configured a load balancer virtual server on a Tier-1 Gateway. In order to advertise the load balancer virtual IP to the Tier-0 Gateway, which route advertisement configuration has to be done on the Tier-1 Gateway? (Choose two.)

Which three steps are required to create an IPsec VPN tunnel? (Choose three.)

Which two choices are solutions of the NSX portfolio (Choose two)?

An NSX Administrator has created a segment named WEB-LS from the NSX UI and noticed the segment is not realized on the KVM Transport node. What are two possible causes for this issue? (Choose two.)

Question 57 - 2V0-41.20 discussion

Report

An NSX administrator is creating a Tier-1 Gateway configured in Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original failed node to become the Active node upon recovery.

Which failover policy meets this requirement?

A.

Non-Preemptive

B.

Preemptive

C.

Enable Preemptive

D.

Disable Preemptive

Show Answer

asked 16/09/2024

mariam alsallal

40 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first