Home / VMware / 2V0-41.20

Question list

List of questions

Question 1

(0)

An NSX administrator noticed that the nsxcli command times out after 600 secs of idle time. Which CLI command disables the nsxcli time out value on NSX Manager?

Question 2

(0)

An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy. Which profile allows the administrator to configure th

Question 3

(0)

Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.)

Question 4

(0)

Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?

Question 5

(0)

Which three steps are required to create an IPsec VPN tunnel? (Choose three.)

Question 6

(0)

An NSX administrator wants to create a Tier-0 Gateway to support equal cost multi-path (ECMP) routing. Which failover detection protocol must be used to meet this requirement?

Question 7

(0)

What are two supported N-VDS modes? (Choose two.)

Question 8

(0)

A user is assigned these two roles in NSX Manager: LB Admin Network Engineer What privileges does this user have in the system?

Question 9

(0)

An NSX administrator has configured a KVM hypervisor as a transport node. Which kernel module on KVM implements a N-VDS?

Question 10

(0)

Which CLI command should be executed on a KVM hypervisor to retrieve the VM interface UUID?

Question 89 - 2V0-41.20 discussion

Which CLI command is used to disable SSH timeout on NSX Manger and NSX Edge nodes?

A.

set cli ssh timeout 0

B.

set esxcli ssh session off

C.

set cli-timeout 0

D.

nsxcli ssh session on

Show Answer

asked 16/09/2024

Nelson G Porras

42 questions

Your answer: A B C D

0 comments

Sorted by