Question 403 - 220-1101 discussion

The correct answer is B. Install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run.

The problem is most likely caused by the excessive length of the Cat 5 UTP cable, which exceeds the maximum limit of 100 meters (328 feet) for Ethernet over twisted pair12. This can result in signal degradation, interference, and packet loss, which can affect the network performance and connectivity. The flashing green LED indicates that the NIC is receiving data, while the flashing orange

LED indicates that the NIC is sending data3. However, these LEDs do not indicate the quality or speed of the data transmission, which may be poor due to the long cable run.

The best solution is to install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run. A powered hub is a device that can amplify and regenerate the signal, as well as provide additional ports for connecting more devices. A powered hub can extend the effective range of the cable and improve the network performance and connectivity1.

The other options are not the best solutions for this problem. Checking for loose connections, pinched bends, and physical damage is a good troubleshooting step, but it is unlikely to solve the problem if the cable is too long. Replacing the entire run of Cat 5 UTP cable with Cat 5 STP cable may reduce some interference, but it will not solve the problem of signal degradation due to the length.

Upgrading the entire cable run to multimode fiber may provide better performance and range, but it will also require replacing the NICs and switches, which will be costly and time-consuming.