Why choose Cisco DNA Center for automated lifecycle management?

To provide fast and accurate deployment of patches and updates

To perform upgrades without service interruption

To provide fast and accurate deployment of patches and updates

To allow SSH access to all nodes in the network.

To provide software redundancy in the network.

Which mechanism allows WPA3 to provide a higher degree of security than its predecessors?

SAE password-based key exchange

special-character support in preshared Keys

SAE password-based key exchange

certificate-based authentication

Exhibit. The switches are connected via a Cat5 Ethernet cable that was successfully tested. The Interfaces are configured as access ports and are both in a 'down' status. What is the cause of this issue?

The speed settings on the switches are mismatched.

The switches are configured with incompatible duplex settings.

The distance between the two switches is not supported by Cut5.

The speed settings on the switches are mismatched.

The portfast command is missing from the configuration.

Refer to the exhibit. Refer to the exhibit. How will the device handle a packet destined to IP address 100.100.100.100?

If will choose the route with the longest match. O 100.100.100.100'32 (110/21) via 192.168.1.1. 00:05:57. EmernetO/1.

It will always prefer the static route over dynamic routes and choose the route S 100.100.0.0/16(1/0] via 192.168.4.1.

It will choose the route with the highest metric. D 100.100.100.0/24 (90/435200) via 192.168.2.1. 00:00:13. EthernetO/2.

It will choose the route with the lowest metric, R 100.0.0.0/8 [120/2] via 192.168.3.1. 00:00:13. EthernetO/3.

An engineer must configure a core router with a floating static default route to the backup router at 10.200.0.2. Which command meets the requirements?

Ip route 0.0.0.0 0.0.0.0 10.200.0.2 10

ip route 0.0.0.0 0.0.0.0 10.200.0.2 1

Ip route 0.0.0.0 0.0.0.0 10.200.0.2 floating

ip route 0.0.0.0 0.0.0.0 10.200.0.2

Ip route 0.0.0.0 0.0.0.0 10.200.0.2 10

Refer to the exhibit. Refer to the exhibit. An engineer is creating a secure preshared key based SSID using WPA2 for a wireless network running on 2.4 GHz and 5 GHz. Which two tasks must the engineer perform to complete the process? (Choose two.)

Select the AES option for Auth Key Management.

Select the AES (CCMP128) option for WPA2/WPA3 Encryption.

Select the 802.1 x option for Auth Key Management.

Select the PSK option for Auth Key Management.

Select the AES option for Auth Key Management.

Select the AES (CCMP128) option for WPA2/WPA3 Encryption.

Refer to the exhibit. Refer to the exhibit. A network engineer updates the existing configuration on interface fastethernet1/1 switch SW1. It must establish an EtherChannel by using the same group designation with another vendor switch. Which configuration must be performed to complete the process?

interface fasteinernet 1/1 channel-group 2 mode active

interface port-channel 2 channel-group 2 mode desirable

interface fasteinernet 1/1 channel-group 2 mode active

interface fasteinernet 1/1 channel-group 2 mode on

interface port-channel 2 channel-group 2 mode auto

A HCP pool has been created with the name CONTROL. The pool uses the next to last usable IP address as the default gateway for the DHCP clients. The server is located at 172.16 32.15. What is the step in the process for clients on the 192.168.52.0/24 subnet to reach the DHCP server?

ip default-network 192.168.52.253

ip default-gateway 192.168.52.253

Refer to the exhibit. The user has connectivity to devices on network 192.168.3 0/24 but cannot reach users on the network 10.10.1.0724.What is the first step to verify connectivity?

Is the default gateway reachable?

What is the main difference between traditional networks and controller-based networking?

Controller-based networks are open for application requests, and traditional networks operate manually.

Controller-based networks increase TCO for the company, and traditional networks require less investment.

Controller-based networks provide a framework for Innovation, and traditional networks create efficiency.

Controller-based networks are open for application requests, and traditional networks operate manually.

Controller-based networks are a closed ecosystem, and traditional networks take advantage of programmability.

Refer to the exhibit. Refer to the exhibit. IPv6 is being Implemented within the enterprise. The command Ipv6 unlcast-routing is configure. Interlace GlgO/0 on R1 must be configured to provide a dynamic assignment using the assigned IPv6 block Which command accomplishes this task?

ipv6 address 2001:DB8:FFFF:FCF3::/64 eui-64

ipv6 address 2001:DB8:FFFF:FCF3::1/64

ipv6 address autoconfig 2001:DB8:FFFF:FCF2::/64

ipv6 address 2001:DB8:FFFF:FCF3::/64 eui-64

ipv6 address 2001:DB8:FFFF:FCF3::/64 link-local

Refer to the exhibit. Refer to the exhibit. A network administrator is configuring a router for user access via SSH. The service-password encryption command has been issued. The configuration must meet these requirements:* Create the username as CCUser.* Create the password as NA!2Scc.* Encrypt the user password.What must be configured to meet the requirements?

username CCUser privies 10 password NA!2Scc

username CCUser password NA!2Scc enable password level 5 NA!2$cc

username CCUser privilege 15 password NA!2Scc enable secret 0 NA!2$cc

Which solution is appropriate when mitigating password attacks where the attacker was able to sniff the clear-text password of the system administrator?

next-generation firewall to keep stateful packet inspection

multifactor authentication using two separate authentication sources

ACL to restrict incoming Telnet sessions 'admin' accounts

IPS with a btock list of known attack vectors

What are two lacts that differentiate optical-fiber cabling from copper cabling? (Choose two.)

It provides greater throughput options.

It carries signals for longer distances.

It is less expensive when purchasing patch cables.

It has a greater sensitivity to changes in temperature and moisture.

It provides greater throughput options.

It carries signals for longer distances.

It carries electrical current further distances for PoE devices.

Refer to the exhibit. Refer to the exhibit. Which functionalities will this SSID have while being used by wireless clients?

decreases network security against air sniffing attacks and discourages the use of complex passwords

decreases network security against offline dictionary attacks and encourages easy access to the network

increases network security against offline dictionary attacks and discourages time-consuming brute force attacks

increases network security against man in the middle attacks and discourages denial of service attacks

decreases network security against air sniffing attacks and discourages the use of complex passwords

Refer to the exhibit. Refer to the exhibit Routers R1 R2 and R3 use a protocol to identify their neighbors' IP addresses hardware platforms, and software versions. A network engineer must configure R2 to avoid sharing any neighbor information with R3, and maintain its relationship with R1. What action meets this requirement?

Configure the no cdp enable command on gO/2.

Configure the no cdp run command globally.

Configure the no lldp run command globally.

Configure the no lldp receive command on gQV1.

What is the difference between controller-based networks and traditional networks as they relate to control-plane and/or data-plane functions?

Controller-based networks centralize all important data-plane functions, and traditional networks distribute data-plane functions.

Controller-based networks centralize all important control-plane functions, and traditional networks distribute control-plane functions.

Traditional networks centralize all important control-plane functions, and controller-based networks distribute control-plane functions.

Traditional networks centralize all important data-plane functions, and controller-based networks distribute data-plane functions.

Refer to the exhibit. Refer to the exhibit. An engineer just installed network 10.120.10.0/24. Which configuration must be applied to the R14 router to add the new network to its OSPF routing table?

router ospf 120network 10.120.10.0 255.255.255.0 area 0ip route 10.120.10.0 255.255.255.0 fa0/1

router ospf 100network 10.120.10.0 255.255.255.0 area 0

router ospf 120network 10.120.10.0 255.255.255.0 area 0ip route 10.120.10.0 255.255.255.0 fa0/1

router ospf 100 area 0network 10.120.10.0 0.0.0.255

How does machine learning improve the detection of unauthorized network access?

It monitors for outdated software.

It dictates security policy updates.

It identifies patterns indicating intrusions.

It assigns security clearance levels.

Which two statements distinguish authentication from accounting? (Choose two.)

Only authentication challenges users for their credentials and returns a response.

Only authentication validates 'who you are.'

Only authentication records the duration of a user's connection.

Only authentication supports user-activity audits.

Only authentication provides supporting information for billing users.

Only authentication challenges users for their credentials and returns a response.

Only authentication validates 'who you are.'

Refer to the exhibit. Refer to the exhibit. An engineer is using the Cisco WLC GUI to configure a WLAN for WPA2 encryption with AES and preshared key Cisc0123456. After the engineer selects the WPA + WPA2 option from the Layer 2 Security drop-down list, which two tasks must they perform to complete the process? (Choose two.)

Select PSK from the Auth Key Mgmt drop-down list, set the PSK Format to ASCII, and enter the key.

Select the WPA2 Policy and AES check boxes.

Select the WPA2 Policy, AES, and TKIP check boxes.

Select ASCII from the PSK Format drop-down list, enter the key, and leave the Auth Key Mgmt setting blank.

Select PSK from the Auth Key Mgmt drop-down list, set the PSK Format to ASCII, and enter the key.

Select the WPA2 Policy and AES check boxes.

Refer to the exhibit. Refer to the exhibit. This ACL is configured to allow client access only to HTTP, HTTPS, and DNS services via UDP. The new administrator wants to add TCP access to the DNS service. Which configuration updates the ACL efficiently?

ip access-list extended Services35 permit tcp 10.0.0.0 0.255.255.255 host 198.51.100.11 eq domain

no ip access-list extended Servicesip access-list extended Services30 permit tcp 10.0.0.0 0.255.255.255 host 198.51.100.11 eq domain

ip access-list extended Servicespermit tcp 10.0.0.0 0.255.255.255 host 198.51.100.11 eq domain

no ip access-list extended Servicesip access-list extended Servicespermit udp 10.0.0.0 0.255.255.255 any eq 53permit tcp 10.0.0.0 0.255.255.255 host 198.51.100.11 eq domaindeny ip any any log

Which advantage does machine learning offer for network security?

It improves real-time threat detection.

It enforces password complexity requirements.

It controls VPN access permissions.

Cisco 200-301 Practice Test 25 - Free Online Exam Questions 961-1000

Spam

Selling illegal goods, money scams etc.

Hate Speech

Serious attack on a group.

Harassment and bullying

Harassing an individual (including doxing)

Harmful activities

Threatening or glorifying violence or serious harm, including self-harm

Adult content (Consensual)

Nudity/Sexual content

Sexual exploitation and abuse (child safety)

Sexually explicit or suggestive imagery or writing involving minors

Sexual exploitation and abuse (adults and animals)

Sexually explicit or suggestive imagery or writing involving non-consenting adults or non-humans

Plagiarism

Reusing content without attribution (link and blockquotes)

Poorly written

Not in English or has very bad formatting, grammar, and spelling

Inappropriate credential

Author's credential is offensive, spam, or impersonation

Other

Ex. Illegal content, incomplete question...

Cisco 200-301 Practice Test 25

Question

Cisco 200-301 Practice Tests

Practice Tests