What are two roles of the Dynamic Host Configuration Protocol (DHCP)? (Choose two)

The DHCP server offers the ability to exclude specific IP addresses from a pool of IP addresses

The DHCP server leases client IP addresses dynamically.

The DHCP server offers the ability to exclude specific IP addresses from a pool of IP addresses

The DHCP client can request up to four DNS server addresses

The DHCP server assigns IP addresses without requiring the client to renew them

The DHCP server leases client IP addresses dynamically.

The DHCP client maintains a pool of IP addresses it can assign.

Which two outcomes are predictable behaviors for HSRP? (Choose two )

The two routers negotiate one router as the active router and the other as the standby router

The two routers share a virtual IP address that is used as the default gateway for devices on the LAN

The two routers synchronize configurations to provide consistent packet forwarding

The two routers negotiate one router as the active router and the other as the standby router

Each router has a different IP address, both routers act as the default gateway on the LAN, and traffic is load-balanced between them

The two routers share a virtual IP address that is used as the default gateway for devices on the LAN

The two routers share the same interface IP address and default gateway traffic is load-balanced between them

Several new coverage cells are required to improve the Wi-Fi network of an organization. Which two standard designs are recommended? (choose two.)

For maximum throughput, the WLC is configured to dynamically set adjacent access points to the same channel.

Cells that overlap one another are configured to use nonoveriapping channels.

5GHz provides increased network capacity with up to 23 nonoveriapping channels.

For maximum throughput, the WLC is configured to dynamically set adjacent access points to the same channel.

5GHz channel selection requires an autonomous access point.

Adjacent cells with overlapping channels use a repeater access point.

Cells that overlap one another are configured to use nonoveriapping channels.

Refer to the exhibit. What commands are needed to add a subinterface to Ethernet0/0 on R1 to allow for VLAN 20, with IP address 10.20.20.1/24?

R1(config)#interface ethernet0/0.20R1(config)#encapsulation dot1q 20R1(config)#ip address 10.20.20.1 255.255.255.0

R1(config)#interface ethernet0/0R1(config)#encapsulation dot1q 20R1(config)#ip address 10.20.20.1 255.255.255.0

R1(config)#interface ethernet0/0.20R1(config)#encapsulation dot1q 20R1(config)#ip address 10.20.20.1 255.255.255.0

R1(config)#interface ethernet0/0.20R1(config)#ip address 10.20.20.1 255.255.255.0

R1(config)#interface ethernet0/0R1(config)#ip address 10.20.20.1 255.255.255.0

Which purpose does a northbound API serve in a controller-based networking architecture?

facilitates communication between the controller and the applications

communicates between the controller and the physical network hardware

reports device errors to a controller

generates statistics for network hardware and traffic

facilitates communication between the controller and the applications

What is the primary purpose of a First Hop Redundancy Protocol?

It reduces routing failures by allowing more than one router to represent itself, as the default gateway of a network.

It allows directly connected neighbors to share configuration information.

It allows a router to use bridge priorities to create multiple loop-free paths to a single destination.

It reduces routing failures by allowing Layer 3 load balancing between OSPF neighbors that have the same link metric.

It reduces routing failures by allowing more than one router to represent itself, as the default gateway of a network.

What occurs to frames during the process of frame flooding?

Frames are sent to every port on the switch in the same VLAN except from the originating port

Frames are sent to every port on the switch that has a matching entry in the MAC address table.

Frames are sent to all ports, including those that are assigned to other VLANs.

Frames are sent to every port on the switch in the same VLAN.

Refer to the exhibit. Which configuration on RTR-1 denies SSH access from PC-1 to any RTR-1 interface and allows all other traffic?

access-list 100 deny tcp host 172.16.1.33 any eq 22 access-list 100 permit ip any any line vty 0 15 ip access-group 100 in

access-list 100 deny tcp host 172.16.1.33 any eq 22 access-list 100 permit ip any any interface GigabitEthernet0/0 ip access-group 100 in

access-list 100 deny tcp host 172.16.1.33 any eq 22 access-list 100 permit ip any any line vty 0 15 ip access-group 100 in

access-list 100 deny tcp host 172.16.1.33 any eq 23 access-list 100 permit ip any any interface GigabitEthernet0/0 ip access-group 100 in

access-list 100 deny tcp host 172.16.1.33 any eq 23 access-list 100 permit ip any any line vty 0 15 ip access-group 100 in

In which two ways does a password manager reduce the chance of a hacker stealing a users password? (Choose two.)

It protects against keystroke logging on a compromised device or web site.

It encourages users to create stronger passwords.

It automatically provides a second authentication factor that is unknown to the original user.

It uses an internal firewall to protect the password repository from unauthorized access.

It protects against keystroke logging on a compromised device or web site.

It stores the password repository on the local workstation with built-in antivirus and anti-malware functionality

It encourages users to create stronger passwords.

What are two roles of Domain Name Services (DNS)? (Choose Two)

enables applications to identify resources by name instead of IP address

allows a single host name to be shared across more than one IP address

builds a flat structure of DNS names for more efficient IP operations

encrypts network Traffic as it travels across a WAN by default

improves security by protecting IP addresses under Fully Qualified Domain Names (FQDNs)

enables applications to identify resources by name instead of IP address

allows a single host name to be shared across more than one IP address

How do TCP and UDP differ in the way they guarantee packet delivery?

TCP uses checksum, acknowledgement, and retransmissions, and UDP uses checksums only.

TCP uses two-dimensional parity checks, checksums, and cyclic redundancy checks and UDP uses retransmissions only.

TCP uses checksum, parity checks, and retransmissions, and UDP uses acknowledgements only.

TCP uses retransmissions, acknowledgement and parity checks and UDP uses cyclic redundancy checks only.

What are two benefits of controller-based networking compared to traditional networking?

Controller-based reduces network configuration complexity, while traditional increases the potential for errors

Controller-based provides centralization of key IT functions. While traditional requires distributes management function

controller-based increases network bandwidth usage, while traditional lightens the load on the network.

controller-based inflates software costs, while traditional decreases individual licensing costs

Controller-based reduces network configuration complexity, while traditional increases the potential for errors

Controller-based provides centralization of key IT functions. While traditional requires distributes management function

controller-based allows for fewer network failure, while traditional increases failure rates.

Refer to the exhibit. Which outcome is expected when PC_A sends data to PC_B?

The source and destination MAC addresses remain the same.

The switch rewrites the source and destination MAC addresses with its own.

The source MAC address is changed.

The source and destination MAC addresses remain the same.

The destination MAC address is replaced with ffff.ffff.ffff.

How will Link Aggregation be Implemented on a Cisco Wireless LAN Controller?

One functional physical port is needed to pass client traffic.

The EthernetChannel must be configured in "mode active".

When enabled, the WLC bandwidth drops to 500 Mbps.

To pass client traffic, two or more ports must be configured.

Which configuration ensures that the switch is always the root for VLAN 750?

Switch(config)#spanning-tree vlan 750 priority 0

Switch(config)#spanning-tree vlan 750 priority 38003685

Switch(config)#spanning-tree vlan 750 root primary

Switch(config)#spanning-tree vlan 750 priority 614440

Switch(config)#spanning-tree vlan 750 priority 0

Which WAN access technology is preferred for a small office / home office architecture?

dedicated point-to-point leased line

Integrated Services Digital Network switching.

What criteria is used first during me root port selection process?

lowest path cost to the root bridge

What criteria is used first during the root port selection process?

lowest path cost to the root bridge

What is a function of Wireless LAN Controller?

send LWAPP packets to access points.

register with a single access point that controls traffic between wired and wireless endpoints.

use SSIDs to distinguish between wireless clients.

send LWAPP packets to access points.

monitor activity on wireless and wired LANs

Which type of information resides on a DHCP server?

a list of the available IP addresses in a pool

a list of public IP addresses and their corresponding names

usernames and passwords for the end users in a domain

a list of statically assigned MAC addresses

A manager asks a network engineer to advise which cloud service models are used so employees do not have to waste their time installing, managing, and updating software which is only used occasionally Which cloud service model does the engineer recommend?

business process as service to support different types of service

A port security violation has occurred on a switch port due to the maximum MAC address count being exceeded. Which command must be configured to increment the security-violation count and forward an SNMP trap?

switchport port-security violation restrict

switchport port-security violation access

switchport port-security violation protect

switchport port-security violation restrict

switchport port-security violation shutdown

What are two functions of a Layer 2 switch? (Choose two)

acts as a central point for association and authentication servers

makes forwarding decisions based on the MAC address of a packet

acts as a central point for association and authentication servers

selects the best route between networks on a WAN

moves packets between different VLANs

makes forwarding decisions based on the MAC address of a packet

Cisco 200-301 Practice Test 5 - Free Online Exam Prep & Questions

Question 1 / 40

Refer to the exhibit.

Cisco 200-301 image Question 61 109569 10072024004420000000

The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2 while all other VLANs are to remain tagged.

Which command accomplishes this task?

switchport access vlan 67

switchport trunk allowed vlan 67

switchport private-vlan association host 67

switchport trunk native vlan 67

Comment (0)

Cisco 200-301 Practice Test 5

Question

Cisco 200-301 Practice Tests

Practice Tests