If a switch port receives a new frame while it is actively transmitting a previous frame, how does it process the frames?

The previous frame is delivered, the new frame is dropped, and a retransmission request is sent.

The new frame is delivered first, the previous frame is dropped, and a retransmission request is sent.

The previous frame is delivered, the new frame is dropped, and a retransmission request is sent.

The new frame is placed in a queue for transmission after the previous frame.

The two frames are processed and delivered at the same time.

Refer to the exhibit. An engineer configured the New York router with state routes that point to the Atlanta and Washington sites. When command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?

ip route 0.0.0.0.0.0.0.0 Serial 0/0/0

What is a difference between RADIUS and TACACS+?

TACACS+ separates authentication and authorization, and RADIUS merges them

RADIUS is most appropriate for dial authentication, but TACACS+ can be used for multiple types of authentication

TACACS+ encrypts only password information and RADIUS encrypts the entire payload

TACACS+ separates authentication and authorization, and RADIUS merges them

RADIUS logs all commands that are entered by the administrator, but TACACS+ logs only start, stop, and interim commands

What Is a syslog facility?

group of log messages associated with the configured severity level

Host that is configured for the system to send log messages

password that authenticates a Network Management System to receive log messages

group of log messages associated with the configured severity level

set of values that represent the processes that can generate a log message

What are two characteristics of a public cloud Implementation? (Choose two.)

It provides services that are accessed over the Internet.

It supports network resources from a centralized third-party provider and privately-owned virtual resources

It is owned and maintained by one party, but it is shared among multiple organizations.

It enables an organization to fully customize how It deploys network resources.

It provides services that are accessed over the Internet.

It Is a data center on the public Internet that maintains cloud services for only one company.

It supports network resources from a centralized third-party provider and privately-owned virtual resources

Refer to the exhibit. How does router R1 handle traffic to 192.168.10.16?

It selects the RIP route because it has the longest prefix inclusive of the destination address.

It selects the IS-IS route because it has the shortest prefix inclusive of the destination address.

It selects the EIGRP route because it has the lowest administrative distance.

It selects the OSPF route because it has the lowest cost.

It selects the RIP route because it has the longest prefix inclusive of the destination address.

What role does a hypervisor provide for each virtual machine in server virtualization?

control and distribution of physical resources

services as a hardware controller.

What is the function of a server?

It provides shared applications to end users.

It transmits packets between hosts in the same broadcast domain.

It provides shared applications to end users.

It routes traffic between Layer 3 devices.

It Creates security zones between trusted and untrusted networks

Refer to the exhibit. What is the effect of this configuration?

The switch discard all ingress ARP traffic with invalid MAC-to-IP address bindings.

All ARP packets are dropped by the switch

Egress traffic is passed only if the destination is a DHCP server.

All ingress and egress traffic is dropped because the interface is untrusted

The switch discard all ingress ARP traffic with invalid MAC-to-IP address bindings.

What is a characteristic of private IPv4 addressing?

used without tracking or registration

traverse the Internet when an outbound ACL is applied

issued by IANA in conjunction with an autonomous system number

composed of up to 65.536 available addresses

used without tracking or registration

Refer to the exhibit. Which configuration issue is preventing the OSPF neighbor relationship from being established between the two routers?

R1 interface Gil/0 has a larger MTU size

R2 is using the passive-interface default command

R1 has an incorrect network command for interface Gi1/0

R2 should have its network command in area 1

R1 interface Gil/0 has a larger MTU size

Refer to the exhibit. A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?

207.165.200.254 via Serial0/0/1

207.165.200.246 via Serial0/1/0

207.165.200.254 via Serial0/0/1

207.165.200.254 via Serial0/0/0

207.165.200.250 via Serial/0/0/0

What are two differences between optical-fiber cabling and copper cabling? (Choose two)

Light is transmitted through the core of the fiber

The glass core component is encased in a cladding

Light is transmitted through the core of the fiber

A BNC connector is used for fiber connections

The glass core component is encased in a cladding

Fiber connects to physical interfaces using Rj-45 connections

The data can pass through the cladding

How does WPA3 improve security?

It uses SAE for authentication.

It uses a 4-way handshake for authentication.

Refer to the exhibit. An engineer deploys a topology in which R1 obtains its IP configuration from DHCP. If the switch and DHCP server configurations are complete and correct. Which two sets of commands must be configured on R1 and R2 to complete the task? (Choose two)

R2(config)# interface gi0/0R2(config-if)# ip helper-address 198.51.100.100

R1(config)# interface fa0/0R1(config-if)# ip address dhcpR1(config-if)# no shutdown

R1(config)# interface fa0/0R1(config-if)# ip helper-address 198.51.100.100

R2(config)# interface gi0/0R2(config-if)# ip helper-address 198.51.100.100

R1(config)# interface fa0/0R1(config-if)# ip address dhcpR1(config-if)# no shutdown

R2(config)# interface gi0/0R2(config-if)# ip address dhcp

R1(config)# interface fa0/0R1(config-if)# ip helper-address 192.0.2.2

When OSPF learns multiple paths to a network, how does it select a route?

It divides a reference bandwidth of 100 Mbps by the actual bandwidth of the existing interface to calculate the router with the lowest cost.

It multiple the active K value by 256 to calculate the route with the lowest metric.

For each existing interface, it adds the metric from the source router to the destination to calculate the route with the lowest bandwidth.

It divides a reference bandwidth of 100 Mbps by the actual bandwidth of the existing interface to calculate the router with the lowest cost.

It count the number of hops between the source router and the destination to determine the router with the lowest metric

How do AAA operations compare regarding user identification, user services and access control?

Authentication identifies users and accounting tracks user services

Authorization provides access control and authentication tracks user services

Authentication identifies users and accounting tracks user services

Accounting tracks user services, and authentication provides access control

Authorization identifies users and authentication provides access control

An engineer requires a scratch interface to actively attempt to establish a trunk link with a neighbor switch. What command must be configured?

switchport mode dynamic desirable

Refer to the exhibit. A packet is being sent across router R1 to host 172.16.0.14. What is the destination route for the packet?

209.165.200.254 via Serial0/0/1

209.165.200.254 via Serial0/0/0

209.165.200.246 via Serial0/1/0

209.165.200.250 via Serial0/0/0

With REST API, which standard HTTP header tells a server which media type is expected by theclient?

Accept-Patch: text/example; charset=utf-8

Content-Type: application/json; charset=utf-8

What is the expected outcome when an EUI-64 address is generated?

The seventh bit of the original MAC address of the interface is inverted

The interface ID is configured as a random 64-bit value

The characters FE80 are inserted at the beginning of the MAC address of the interface

The MAC address of the interface is used as the interface ID without modification

The SW1 interface g0/1 is in the down/down state. Which two configurations are valid reasons for the interface conditions?(choose two)

The interface is error-disabled

Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?

configure a stateful DHCPv6 server on the network

explicitly assign a link-local address

Refer to the exhibit. Which command configures a floating static route to provide a backup to the primary link?

ip route 209.165.200.224 255.255.255.224 209.165.202.129 254

ip route 0.0.0.0 0.0.0.0 209.165.202.131

ip route 209.165.201.0 255.255.255.224 209.165.202.130

ip route 0.0.0.0 0.0.0.0 209.165.200.224

ip route 209.165.200.224 255.255.255.224 209.165.202.129 254

Refer to the exhibit. An access list is created to deny Telnet access from host PC-1 to RTR-1 and allow access from all other hosts A Telnet attempt from PC-2 gives this message:"% Connection refused by remote host" Without allowing Telnet access fromPC-1, which action must be taken to permit the traffic?

Add the access-list 10 permit any command to the configuration

Remove the access-class 10 in command from line vty 0.4.

Add the ip access-group 10 out command to interface g0/0.

Remove the password command from line vty 0 4.

Cisco 200-301 Practice Test 9 - Free Online Exam Prep & Questions

An engineer must establish a trunk link between two switches. The neighboring switch is set to trunk or desirable mode. What action should be taken?

Become a Premium Member for full access

Unlock Premium Member

Cisco 200-301 Practice Test 9

Question

Cisco 200-301 Practice Tests

Practice Tests