Home / VCE / 220-010

VCE 220-010 Practice Test - Questions Answers, Page 5

Question list

List of questions

Question 41

(0)

You are working on latency problems with a storage pool in your Vblock® System 340. After investigation, you decide that the FAST Cache must be expanded on the VNX. What is required to accomplish t

Question 42

(0)

You are asked to create a series of LUNs within a storage pool that will be used as VMFS data stores and you are unsure what the performance requirements will be. According to EMC, which FAST Tieri

Question 43

(0)

Your Vblock® System 720 was set up with a FAST VP policy of 100% EFD, 100% FC, with 100% SATA, and then applied the policy to all the storage groups. You have allocated all thin LUNs from the Fibre

Question 44

(0)

You are asked to add a new ESXi host to an existing VMware cluster. You identify an available blade with the same specifications. Which statement is a VCE recommendation?

Question 45

(0)

You have added physical disks to your Vblock® System 720 to a physical disk group and then created data devices. What must you do to see the new capacity?

Question 46

(0)

Click the Exhibit button. -- Exhibit -- -- Exhibit -- You are adding a new VM within vCenter when the error shown in the exhibit occurs. What does this error indicate?

Question 47

(0)

You have a single storage pool that has been dedicated for quality assurance and development purposes. Both groups have submitted requests for LUNs, but the total LUN capacity requested exceeds the

Question 48

(0)

Which UCSM policy defines values for alerts?

Question 49

(0)

Your environment uses resource pool management to automate and enforce device identities in your organization including troubleshooting. In this scenario, which three resources are managed? (Choose

Question 50

(0)

You are using expandable resource pools in your VMware cluster to ensure each environment is allocated the appropriate resources. There is a resource pool for your development environment that has a

Question 41

You are working on latency problems with a storage pool in your Vblock® System 340. After investigation, you decide that the FAST Cache must be expanded on the VNX.

What is required to accomplish this task?

All additional EFD drives must be in the same storage pool as the existing FAST Cache drives.

A separate FAST VP cache is created and storage pools are migrated to it.

The existing FAST Cache must be deleted and the entire cache re-created.

SP Write Cache must be disabled for all pools using FAST Cache prior to expansion.

Show Answer Comment (0)

Question 42

You are asked to create a series of LUNs within a storage pool that will be used as VMFS data stores and you are unsure what the performance requirements will be.

According to EMC, which FAST Tiering Policy should you use?

Auto-Tier

Start High then Auto-Tier

Highest Available Tier

Lowest Available Tier

Show Answer Comment (0)

Your Vblock® System 720 was set up with a FAST VP policy of 100% EFD, 100% FC, with 100% SATA, and then applied the policy to all the storage groups. You have allocated all thin LUNs from the Fibre Channel pool and would like to ensure that all but 10% of the EFD drives can be used by the FAST policy.

Which setting would you use to accomplish this task?

Adjust the Pool Reserved Capacity to 10.

Adjust the compression rate to 10.

Adjust the Data Movement Mode to 10.

Adjust the Relocation Rate to 10.

Show Answer Comment (0)

Question 44

You are asked to add a new ESXi host to an existing VMware cluster. You identify an available blade with the same specifications.

Which statement is a VCE recommendation?

Hosts in a VMware cluster should each belong to a different VSAN.

Service profiles in a VMware cluster should be kept on as few chassis as possible.

Service profiles in a VMware cluster should be spread out over as many Vblock® Systems as possible.

Hosts in a VMware cluster should always belong to the same service profile template.

Show Answer Comment (0)

Question 45

You have added physical disks to your Vblock® System 720 to a physical disk group and then created data devices.

What must you do to see the new capacity?

Add the devices to the masking group.

Map the devices to the front end ports.

Add the devices to the thin pool and enable them.

Add the devices to the FAST VP policy.

Show Answer Comment (0)

Question 46

Click the Exhibit button.

-- Exhibit --

You are adding a new VM within vCenter when the error shown in the exhibit occurs.

What does this error indicate?

The Standard vSwitch has run out of ports.

The Standard vSwitch has run out of port licenses.

The Nexus 1000V switch has run out of port licenses.

The Nexus 1000V switch has run out of ports.

Show Answer Comment (0)

Question 47

You have a single storage pool that has been dedicated for quality assurance and development purposes. Both groups have submitted requests for LUNs, but the total LUN capacity requested exceeds the total available capacity of the pool by several terabytes.

What would you do to satisfy both groups' requests?

Compress the LUNs.

Split the total pool capacity equally between both groups.

Use thin provisioned LUNs to oversubscribe capacity.

Provide network file space to offset the difference.

Show Answer Comment (0)

Question 48

Which UCSM policy defines values for alerts?

Server

Threshold

Firmware

Local Disk

Show Answer Comment (0)

Question 49

Your environment uses resource pool management to automate and enforce device identities in your organization including troubleshooting.

In this scenario, which three resources are managed? (Choose three)

MAC addresses

WWNs

LUN Identifiers

UUIDs

Secured Service Ports

Show Answer Comment (0)

Question 50

You are using expandable resource pools in your VMware cluster to ensure each environment is allocated the appropriate resources. There is a resource pool for your development environment that has a reservation of 5 GHz CPU and 12 GB of memory. There is a child resource pool of the development resource pool named Sandbox that has a reservation of 1 GHz CPU and 4 GB of memory. You create four new virtual machines with 4 GB of memory in the Sandbox environment.

In this scenario, which statement is true?

Only one of the new virtual machines will power on.

All new virtual machines will power on.

Only three of the new virtual machines will power on.

No new virtual machines will power on.

Show Answer Comment (0)

Total 93 questions