Cisco 300-610 Practice Test - Questions Answers, Page 21

An architect is designing a storage solution for a Cisco UCS server infrastructure with these requirements:

* identical deployment of servers

* can add vHBAs to a group of servers

* configuration of servers stays synchronized

Which solution meets these requirements?

Which programming model is vendor-agnostic and combines operational and configuration data in the same container?

Refer to the exhibit.

Refer to the exhibit. An engineer is creating a new data center design for a customer. The design must support virtual applications, enhance network resilience, and meet these requirements:

* Extend Layer 2 across all network segments to support endpoint mobility.

* Access switches will support up to 20 GB capacity for north-south and east-west traffic.

* Provide fast convergence during link failures.

* MAC address advertisement will not depend on the control plane.

Which solution must the engineer include in the design between the access and distribution switches?

DRAG DROP

A customer is deploying a SAN based on Cisco MDS 9000 Series Switches. Each Inter-Switch Link must carry multiple VSANs at the same time. The access switch must share the same domain ID as the director switch to reduce the number of domain IDs needed in the fabric Drag and drop the operational port types from the right onto the boxes on the left to create a topology that meets these requirements. Not all port types are used. Port types are used more than once.

Refer to the exhibit. A Cisco engineer is configuring a FlexPod data center for SAP with Cisco ACI, Cisco UCS Manager 4.0. and Net AppAFFA-Series. All systems and fabric links feature redundancy and provide end-to-end high availability. After the engineer sets the needed VLANs on the NetApp controller ports and adds them to the data broadcast domain, the engineer must make the storage disks visible for the UCS hosts Which action must be taken on the UCS to accomplish this task?

Which two paths are provided by deploying an OOB management network in a data center that uses Cisco Nexus switches? (Choose two.)

Refer to the exhibit. A Cisco engineer is configuring a Cisco UCS integrated infrastructure for SAP HANA that consists of 8 x Cisco UCS B/C480-M5 servers for SAP HAN A and 4 x Cisco UCS C240-M5 C-Series rack mount servers for storage. The rack servers are equipped with Cisco VIC 1225T. The engineer plans to install RHEL8. but the boot process is interrupted at installation because the iSCSl LUNs are not recognized by the VIC adapter. After proper Investigation, the engineer concludes that the initiator and target configuration that is programmed on the primary ISCSl VNIC to the operating system Is missing. What is the reason for the issue?

Refer to the exhibit.

Refer to the exhibit. An engineer deployed a VXLAN fabric with this configuration:

* interface VLAN 100 on VTEP1 with no IP address

* interface VLAN 200 on VTEP4 with no IP address

Which set of actions must the engineer take to ensure that host A communicates with host B?

Refer to the exhibit During a synchronization of port rotes, a device receives a proposal message on one of its ports that is selected as the new root port. The logs show that Rapid PVST+forced all other ports to synchronize with the new loot information. The engineer analyzes the port stales and concludes that the device is synchronized with superior root information received on the root port, and all other ports are synchronized. What happens to a designated port that is in the forwarding state and is not configured as an edge port, if Rapid PVST+ forces it to synchronize with new root information?