Cisco 300-615 Practice Test - Questions Answers, Page 15
Question list
List of questions
Related questions
DRAG DROP
An engineer troubleshoots issues in Cisco UCS Director. Drag and drop the possible causes of the issues from the left onto the corresponding issues on the right.
DRAG DROP
Drag and drop the Cisco UCS SNMP fault types from the left onto the correct issues on the right.
DRAG DROP
Drag and drop the actions from the left onto the faults that they resolve on the right. Not all actions are used.
DRAG DROP
Drag and drop the commands from the left onto the correct categories on the right.
DRAG DROP
A firmware upgrade on a fabric interconnect fails. A bootflash contains a valid image. Drag and drop the recovery steps from the left into the order in which they are implemented on the right.
DRAG DROP
A Cisco Nexus 9000 Series Switch crashes and fails to boot. An engineer must recover the switch and investigate the issue. The switch uses 172.20.50.213/24 IP address for management and its default gateway is 172.20.50.254. Drag and drop the steps for recovering the Cisco Nexus 9000 Series Switch from the left onto the right. Not all steps are used.
DRAG DROP
Drag each item listed on the left to its proper category on the right Not all items will fit the categories.
Refer to the exhibit.
Refer to the exhibit. customer reports that all Intra-EPG isolation stopped working within a baremetal tenant. Postman is running on a machine to get information from the APIC in case of orchestration failure. Which action resolves the issue?.
Remove primaryEncap="vlan-110" from the specific port path.
Match encap="vlan-10" and primaryEncap="vlan-110"
Modify the GET command to reference the valid path for the managed object
Change pcEnfPref="unenforced" to pcEnfPref="enforced".
Refer to the exhibit.
Refer to the exhibit. During a maintenance window of the Nexus switch pair, one of the Cisco Nexus chassis was brought offline for maintenance. The primary Cisco Nexus switch was stable during the maintenance window. After finishing the tasks on the chassis, the administrator wanted to bring the second switch online. The administrator checked the status of the disconnected switch that was removed from the vPC during the maintenance. The engineer must connect the peer chassis seamlessly with the primary vPC peer without experiencing traffic interruption. Which action accomplishes this goal?
Change the role priority, then connect the peer switch.
Change the auto recovery to disabled, and enable auto recovery.
Change the auto recovery timer to active if not already set, then re-establish the connectivity.
Change the auto timer to a higher value, then connect the peer switch.
Refer to the exhibit.
Refer to the exhibit. The monitoring team reports an inability to access the devices after a new centralized management integration. Which action resolves the issue?
Modifly the SNMP ACL to allow the incoming request packets.
Enable SHA authentication for the admin user.
Update the community string.
Change the admin user permissions to write.
Question