ExamGecko
Login
Home / Cisco / 300-615 / List of questions
Ask Question

Cisco 300-615 Practice Test - Questions Answers, Page 17

Add to Whishlist

List of questions

Question 161

Report Export Collapse

An engineer experiences an issue presented with the Cisco ucs system. Which action resolves the issue?

Become a Premium Member for full access
  Unlock Premium Member

Question 162

Report Export Collapse

The VXL AN fabric is deployed with this configuration:

- The VL AN 50 interface has no IP address on VTEP1 and VTEP4.

- The VLAN 100 interface has no IP address on VTEP2 and VTEP3.

- nve1 interface is configured on all VTEPs.

Host A experiences timeouts when attempting to ping host B. Which set of actions allows host A to reach host B7

A. On VTEP1, associate VNI 30000 to Test_ Telco VRF.

On VTEP4, associate VNI 20000 to Test_ Telco VRF.

Become a Premium Member for full access
  Unlock Premium Member

Question 163

Report Export Collapse

A network engineer notices a sudden interruption to the HSRP adjacency between the switches. The packet loss is reported on the servers for which the default gateway is set as the virtual IP of the HSRP. AII servers on the VL AN can exchange ping messages. Which configuration set must be applied on the HSRP peers to resolve the adjacency issue?

Become a Premium Member for full access
  Unlock Premium Member

Question 164

Report Export Collapse

An engineer is implementing, Fibre Channel (FC) switching on a Cisco 9000 Series Switch, but the procedure fails with the message "FC traffic is not being routed through the fabric.". Which action resolves the issue?

Become a Premium Member for full access
  Unlock Premium Member

Question 165

Report Export Collapse

Refer to the exhibit.

Cisco 300-615 image Question 165 113346 10072024010022000000

A network engineer is implementing an RBAC on the Cisco Nexus 9000 Series Switch. The role called Host A fails to clear LACP counters on the port channel 20. Which configuration resolves the issue?

Become a Premium Member for full access
  Unlock Premium Member

Question 166

Report Export Collapse

Refer to the exhibit.

Cisco 300-615 image Question 166 113347 10072024010022000000

An engineer fails to install Perl in the guest shell on a Cisco Nexus 9000 Series Switch. Which two actions must be taken in the guest shell to resolve the issue? (Choose two.)

Become a Premium Member for full access
  Unlock Premium Member
Total 166 questions
Go to page: of 17
Open VPLUS File
Convert VPLUS to PDF

Related questions

DRAG DROP Drag each item listed on the left to its proper category on the right Not all items will fit the categories.
An engineer is implementing a new BGP peering in their new data center. The engineer set up the BGP session that peers with the remote end. As soon as the BGP peers attempt to exchange routing prefixes, one of the BGP peers drops the connection. After reviewing the configuration, the engineer reviews the logging messages. The engineer discovers that the router is missing keepalives from the remote end and terminates the session. Which action resolves the issue?
Refer to the exhibit. Refer to the exhibit. A functioning trunk port Ethernet1/48 exists between two identical Cisco Nexus 5000 Series Switches. The interfaces on the switches support the MACsec feature and are configured identically. To enable manual MACsec, an engineer adds the configuration shown in the exhibit to both sides of the trunk. The trunk port stops functioning. Which action should be taken to resolve the issue?
A network engineer is implementing the Cisco ACI Fabric and notices that the Leaf-1 switch is registered, has an assigned name, but is displayed as inactive in the APIC. After further investigation, it became clear that the leaf switch was recently moved from another Cisco ACI environment. Which action resolves the problem?
Refer to the exhibit. A client configures an upgrade of its Cisco Nexus switches that are connected to the Cisco ACI controller, such that the switches are upgraded one at a time. After the upgrade is run, it is discovered that both Cisco Nexus switches were upgraded simultaneously. Which two actions ensure that the switches upgrade one at a time? (Choose two.)
A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue? A. 1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels 2) Verify that at least two physical cables between the IOM and fabric interconnect function properly. 3) Check for runtime link down status 4) Reseat the affected IOM.
Refer to the exhibit. The FCoE traffic fails to traverse the vfc2 interface. The VSAN 102 is configured for vfc2. Which action resolves the issue?
Refer to the exhibit. Refer to the exhibit. The monitoring team reports an inability to access the devices after a new centralized management integration. Which action resolves the issue?
When the engineer runs the command, this error is received: opsengineer@wkst1:/home/auto/bash_scripts$ curl –s –b cookie_file_39422186.txt –X GET –k 192.15.132.101/api/node/class/Tenant.json {“totalCount”:”1”,”imdata”:[{“error”:{“attributes”:{“code”:”400”,”text”:”Request failed, (output omitted)”}}}]} Which action resolves the issue?
Refer to the exhibit. An administrator directly connects a Fibre Channel storage array to ports 1 through 4 on a Cisco UCS 6454 Fabric Interconnect. The administrator configures a service profile to boot directly from the new Fibre Channel storage array, but the service profile fails to boot. When the administrator checks the output of the show flogi database command on the fabric interconnect, it shows the output presented in the exhibit. Which action resolves the issue?