Cisco 300-620 Practice Test - Questions Answers, Page 19
Question list
List of questions
Related questions
In a Cisco ACI Multi-Site fabric, the Inter-Site BUM Traffic Allow option is enabled in a specific stretched bridge domain. What is used to forward BUM traffic to all endpoints in the same broadcast domain?
ingress replication on the spines in the source site
egress replication on the destination leaf switches
egress replication on the source leaf switches
ingress replication on the spines in the destination site
The engineer notices frequent MAC and IP address moves between different leaf switch ports. Which action prevents this problem from occurring?
Disable enforce subnet check.
Enable endpoint loop protection.
Enable rogue endpoint control.
Disable IP bridge domain enforcement.
A customer is deploying a new application across two ACI pods that is sensitive to latency and jitter.
The application sets the DSCP values of packets to AF31 and CS6, respectively. Which configuration changes must be made on the APIC to support the new application and prevent packets from being delayed or dropped between pods?
disable DSCP mapping on the IPN devices
disable DSCP translation policy
align the ACI QoS levels and IPN QoS policies
align the custom QoS policy on the EPG site in the customer tenant
What controls communication between EPGs?
Inter-EPG communication is controlled by BGP.
Inter-EPG communication is controlled by contracts.
Inter-EPG communication is controlled by IS-IS.
Inter-EPG communication is controlled by VXLAN.
Which feature should be disabled on a bridge domain when a default gateway for endpoints is on an external device instead of a Cisco ACI bridge domain SVI?
unknown unicast flooding
ARP flooding
unicast routing
proxy ARP
Where are STP BPDUSs flooded in Cisco ACI fabric?
in the access encapsulation VLAN part of different VLAN pools
in the bridge domain VLAN
in the native VLAN ID
in the VNID that is assigned to the FD VLAN
Refer to the exhibit.
Refer to the exhibit. An engineer is configuring a production Multi-Site solution to provide connectivity from EPGs from a specific site to networks reachable through a remote site L3OUT. All required schema and template objects are already defined. Which additional configuration must be implemented in the Multi-Site Orchestrator to support the cross-site connectivity?
Configure a routable TEP pool for SITE1.
Enable CloudSec for intersite traffic encryption.
Add a new stretched external EPG to the existing L3OUT.
Implement a policy-based redirect using a service graph.
Refer to the exhibit.
Which two configurations enable inter-VRF communication? (Choose two.)
Set the subnet scope to Shared Between VRFs.
Enable Advertise Externally under the subnet scope.
Export the contract and import as a contract interface.
Change the contract scope to Tenant.
Change the subject scope to VRF.
What are two PBR characteristics of the Cisco ACI Active-Active Across Pods deployment mode in Cisco ACI Multi-Pod design? (Choose two.)
Traffic is dynamically redirected to the firewall that owns the connection.
Deployment occurs in transparent mode.
The connection state is unsynchronized.
Deployment occurs in go-to mode only.
This mode causes the traffic to flow asymmetrically.
Refer to the exhibit.
Refer to the exhibit. What must be configured in the service graph to redirect HTTP traffic betweenthe EPG client and EPG server to go through the Cisco ASA firewall?
precise filter to allow only HTTP traffic
permit-all contract filter
contract with no filter
contract filter to allow ARP and HTTP.
Question