Cisco 300-620 Practice Test - Questions Answers, Page 2
Question list
List of questions
Related questions
An engineer is implementing Cisco ACI at a large platform-as-a-service provider using APIC controllers, 9396PX leaf switches, and 9336PQ spine switches. The leaf switch ports are configured as IEEE 802.1p ports. Where does the traffic exit from the EPG in IEEE 802.1p mode in this configuration?
from leaf ports tagged as VLAN 0
from leaf ports untagged
from leaf ports tagged as VLAN 4094
from leaf ports tagged as VLAN 1
How is an EPG extended outside of the ACI fabric?
Create an external bridged network that is assigned to a leaf port.
Create an external routed network that is assigned to an EPG.
Enable unicast routing within an EPG.
Statically assign a VLAN ID to a leaf port in an EPG.
Which description regarding the initial APIC cluster discovery process is true?
The APIC uses an internal IP address from a pool to communicate with the nodes.
Every switch is assigned a unique AV by the APIC.
The APIC discovers the IP address of the other APIC controllers by using Cisco Discovery Protocol.
The ACI fabric is discovered starting with the spine switches.
Refer to the exhibit.
Which two components should be configured as route reflectors in the ACI fabric? (Choose two.)
Spine1
apic1
Spine2
Leaf1
Leaf2
apic2
When creating a subnet within a bridge domain, which configuration option is used to specify the network visibility of the subnet?
limit IP learning to subnet
scope
gateway IP
subnet control
What does a bridge domain represent?
Layer 3 cloud
Layer 2 forwarding construct
tenant
physical domain
Which table holds IP address, MAC address and VXLAN/VLAN information on a Cisco ACI leaf?
endpoint
adjacency
RIB
ARP
Which two types of interfaces are supported on border leaf switches to connect to an external router? (Choose two.)
subinterface with VXLAN tagging
subinterface with 802.1Q tagging
FEX host interface
out of band interface
Switch Virtual Interface
An engineer is extending an EPG out of the ACI fabric using static path binding. Which statement about the endpoints is true?
Endpoints must connect directly to the ACI leaf port.
External endpoints are in a different bridge domain than the endpoints in the fabric.
Endpoint learning encompasses the MAC address only.
External endpoints are in the same EPG as the directly attached endpoints.
Question