Cisco 300-620 Practice Test - Questions Answers, Page 20

Refer to the exhibit.

Refer to the exhibit. Server A is connected to the Cisco ACI fabric using two teamed interfaces. One interface in a team is configured as active and the other remains in standby mode. When a failover occurs and the standby interface becomes active, it uses its built-in MAC address to send traffic.

Which bridge domain configuration must be applied to resolve the issue?

Which protocol is used in a Multi-Pod topology to synchronize reachability information across pods?

Cisco ACI fabric contains a tenant called Prod. User_1 must have write access to tenant Prod and full access to the fabric access policy. Which set of actions must be taken to meet these requirements?

Refer to the exhibit.

Refer to the exhibit. A client is configuring a new Cisco ACI fabric. All VLANs will be extended during the migration phase using the VPC connections on leaf switches 3. 4 and leaf switches toward the legacy network. The migration phase has these requirements;

* If The legacy switches must be able to transfer BPDUs through the ACI fabric.

* If the legacy switches fail to break a loop. Cisco ACI must break the loop.

Which group settings must be configured on VPC interface policy groups ipg_vpc-legacy_1 and ipg_vpc-legacy_2 to meet these requirements?

What is the result of selecting the On Demand attribute in the Deploy Immediacy feature during VMM domain association to an EPG?

Refer to the exhibit.

The Cisco ACI fabric is built with L20ut to the N9K1 and N9K2 switches. The switches run the RSTP protocol. The requirement is for the Cisco ACI fabric to detect 5 from the N9K and for the fabric to be protected against loops. Which set of actions must be taken to meet the requirements?

A network engineer is implementing a Layer 3 Out in the Cisco ACI fabric. The data center core switches must connect to a pair of leaf switches and exchange routes via a routing protocol. In addition, the implementation must meet these criteria;

* The external switch interface must use 802.1Q tagging.

* Access to the internet for the ACI fabric must be the L30ut.

* The L30ut must use a routing protocol that has rapid convergence time and low CPU usage.

Which configuration set meets these requirements?

Refer to the exhibit.

An engineer must migrate workloads from the brownfield network to the Cisco ACI fabric. The VLAN 10 default gateway remains in the router located in the brownfield Network. The bridge domain has already been associated with L20ut. Which two actions must be taken to migrate the workloads? (Choose two.)

How does Cisco ACI detect the IP address of a silent host that moved from one location to another without notifying a Cisco ACI leaf?