Cisco 300-620 Practice Test - Questions Answers, Page 7
Question list
Related questions
An engineer needs to deploy a leaf access port policy group in ACI Fabric to support the following requirements:
• Control the amount of application data flowing into the system
• Allow the newly connected device to auto-negotiate link speed with the leaf switch Which two ACI policies must be configured to achieve these requirements? (Choose two.)
L2 interface policy
link level policy
slow drain policy
ingress control plane policing policy
ingress data plane policing policy
Which method does the Cisco ACI fabric use to load-balance multidestination traffic?
PIM routing
spanning trees
shortest-path trees
forwarding tag trees
Refer to the exhibit.
Which action should be taken to ensure authentication if the RADIUS servers are unavailable?
Adjust the priority of server 10.1.1.1 to 1.
Set the fallback login to local.
Assign the user to the default role.
Set the default login realm to LDAP
Refer to the exhibit.
An engineer must configure an L3Out peering with the backbone network. The L3Out must forward unicast and multicast traffic over the link. Which two methods should be used to configure L3Out to meet these requirements? (Choose two.)
Layer 3 routed port
VPC with SVI
port channel with SVI
Layer 3 routed subinterface
Layer 3 floating SVI
Refer to the exhibit.
An engineer configures the Cisco ACI fabric for VMM integration with ESXi servers that are to be connected to the ACI leaves. The server team requires the network switches to initiate the LACP negotiation as opposed to the servers. The
LAG group consists of two 10 Gigabit Ethernet links. The server learn also wants to evenly distribute traffic across all available links. Which two enhanced LAG policies meet these requirements? (Choose two.)
LACP Mode: LACP Standby
LB Mode: Destination IP Address and TCP/UDP Port
LB Mode: Source and Destination MAC Address
LB Mode: Source IP Address and TCP/UDP Port
LACP Mode: LACP Active
An engineer must connect Cisco ACI fabric using Layer 2 with external third-party switches. The thirdparty switches are configured using 802.1s protocol. Which two constructs are required to complete the task?
(Choose two.)
spanning tree policy for mapping MST Instances to VLANs
MCP policy with PDU per VLAN enabled
MCP instance policy with administrative slate disabled
dedicated EPG for native VLAN
static binding of native VLAN in all existing EPGs
An engineer configures a Multi-Pod system with the default getaway residing outside of the ACI fabric for a bridge domain. Which setting should be configured to support this requirement?
disable Limit IP Learning to Subnet
disable IP Data-plane Learning
disable Unicast Routing
disable Advertise Host Routes
New ESXi hosts are procured in a data center compute expansion project. An engineer must update the configuration on the Cisco APIC controllers to support the addition of the new servers to the existing VMM domain. Which action should be taken to support this change?
Create a range of internal VLANs in the associated VLAN pool.
Set the encapsulation mode as VXLAN.
Enable infrastructure VLAN in the associated AEP.
Map the leaf interface selector to the AEP that is associated with the VMM domain.
A customer migrates a legacy environment to Cisco ACI. A Layer 2 trunk is configured to interconnect the two environments. The customer also builds ACI fabric in an application-centric mode. Which feature should be enabled in the bridge domain to reduce instability during the migration?
Set Multi-Destination Flooding to Flood in BD.
Enable Flood in Encapsulation.
Set Multi-Destination Flooding to Flood in Encapsulation.
Disable Endpoint Dataplane Learning
An engineer wants to filter the System Faults page and view only the active faults that are present in the Cisco ACI fabric. Which two lifecycle stages must be selected for filtering? (Choose two.)
Raised
Retaining
Soaking, Clearing
Raised, Clearing
Soaking
Question