Cisco 300-815 Practice Test - Questions Answers, Page 12

List of questions
Question 111

Refer to the exhibit.
Which change to the translation rule is needed to strip only the leading 9 from the digit string 9123548?
Question 112

A customer has multisite deployments with a globalized dial plan. The customer wants to route PSTN calls via the gateway assigned to each site. Which two actions will fulfill the requirement? (Choose two.)
Question 113

Refer to the exhibit.
A company needs to ensure that all calls are normalized to E164 format. Which configuration will ensure that the resulting digit string 14085554001 is created and will be routed to the E.164 routing schema?
Question 114

An engineer set up and successfully tested a TEHO solution on the Cisco UCM. PSTN calls are routed correctly using the IP WAN as close to the final PSTN destination as possible. However, suddenly, calls start using the backup local gateway instead. What is causing the issue?
Question 115

An administrator is asked to configure egress call routing by applying globalization and localization on Cisco UCM. How should this be accomplished?
Question 116

Refer to the exhibit.
A Cisco Unified Border Element continues to send 180/183 with the required: 100rel header to Cisco UCM. and the call eventually disconnects How is the issue resolved?
Question 117

An administrator is trying to apply configuration changes on Cisco CME. When the users registered on Cisco CME to dial a local number to a PSTN call, the Cisco CME sends an incorrect number of digits. What translation rule fixes the issue and sends the correct number of digits?
Question 118

Refer to the exhibit.
Which INVITE is sent to 10.10.100.123 as a result of this log?
A)
B)
C)
Question 119

Refer to the exhibit.
A call mode through the Cisco Unified Border Element to pilot 2000 is foiling. What is causing the call to foil?
Question 120

DRAG DROP
Drag and drop the commands from the bottom to the blanks in the code to implement a translation rule to allow only 11 digits to be received over a SIP trunk to a SIP provider. The Cisco UCM is currently sending calls to the Cisco Unified Border Element in E. 164 format. Not all options are used.
Question