ExamGecko
Login
Home / Cisco / 350-401 / List of questions
Ask Question

Cisco 350-401 Practice Test - Questions Answers, Page 61

Add to Whishlist

List of questions

Question 601

Report Export Collapse


Which technology reduces the implementation of STP and leverages both unicast and multicast?

Become a Premium Member for full access
  Unlock Premium Member

Question 602

Report Export Collapse

Using the EIRP formula,what parameter is subtracted to determine the EIRP value?

Become a Premium Member for full access
  Unlock Premium Member

Question 603

Report Export Collapse

Which IP SLA operation requires the IP SLA responder to be configured on the remote end?

Become a Premium Member for full access
  Unlock Premium Member

Question 604

Report Export Collapse

Which two results occur if Cisco DNA Center loses connectivity to devices in the SD-Access fabric? (Choose two)

Become a Premium Member for full access
  Unlock Premium Member

Question 605

Report Export Collapse

An engineer must protect the password for the VTY lines against over-the-shoulder attacks. Which configuration should be applied?

Become a Premium Member for full access
  Unlock Premium Member

Question 606

Report Export Collapse

An engineer is configuring RADIUS-Based Authentication with EAP MS-CHAPv2 is configured on a client device.

Which outer method protocol must be configured on the ISE to support this authentication type?

Become a Premium Member for full access
  Unlock Premium Member

Question 607

Report Export Collapse

Which component handles the orchestration plane of the Cisco SD-WAN?

Become a Premium Member for full access
  Unlock Premium Member

Question 608

Report Export Collapse

What is the rose of the vSmart controller in a Cisco SD-WN environment?

Become a Premium Member for full access
  Unlock Premium Member

Question 609

Report Export Collapse

Refer to the exhibit.

Cisco 350-401 image Question 609 115908 10102024232943000000

R1 has a BGP neighborship with a directly connected router on interface Gi0/0.

Which command set is applied between the iterations of show ip bgp 2.2.2.2?

Become a Premium Member for full access
  Unlock Premium Member

Question 610

Report Export Collapse

Which QoS feature uses the IP Precedence bits in the ToS field of the IP packet header to partition traffic into different priority levels?

Become a Premium Member for full access
  Unlock Premium Member
Total 983 questions
Go to page: of 99
Open VPLUS File
Convert VPLUS to PDF

Related questions

An engineer must configure a multicast UDP jitter operation. Which configuration should be applied? A) B) C) D)
A customer has recently implemented a new wireless infrastructure using WLC-5520 at a site directly next to a large commercial airport. Users report that they intermittently lose WI-FI connectivity, and troubleshooting reveals it is due to frequent channel changes. Which two actions fix this issue? (Choose two)
An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?
Reter to the exhibit. Refer to the exhibit. A network engineer must be notified when a user switches to configuration mode. Which script should be applied to receive an SNMP trap and a critical-level log message?
Refer to the exhibit. An engineer must allow R1 to advertise the 192 168.1 0/24 network to R2 R1 must perform this action without sending OSPF packets to SW1 Which command set should be applied?
What are two differences between the RIB and the FIB? (Choose two.)
Refer to the exhibit. What is the result of this Python code?
What are two benefits of YANG? (Choose two.)
An engineer must use IP SLA to measure the network performance and record statistics hop-by-hop. Which configuration must be used?
A network engineer must configure the VTY lines on a router to achieve these results: Remote access should be permitted for all feasible protocols. Only a password should be required for device authentication. All idle EXEC sessions must be terminated in 60 minutes. Which configuration should be applied?