Cisco 350-501 Practice Test - Questions Answers, Page 18

List of questions
Question 171

Refer to the exhibit.
An engineer is reviewing the BGP configuration. Which routes must be advertised to 10.10.10.1
Question 172

Refer to the exhibit.
AN engineer is configuring segment routing on an ISP to simplify traffic engineering and management across network domains. What should the engineer do to complete the implementation of segment routing?
Question 173

How is a telemetry session established for data analytics?
Question 174

Refer to the exhibit.
An engineer is configuring multitiopology IS-IS for IPv6 on router R1. Which additional configuration must be applied to complete the task?
Question 175

Which two PHY modes are available to implement an IOS XR Gigabit Ethernet interface interface?
(Choose two.)
Question 176

Refer to the exhibit.
A network administrator implemented MPLS LDP changes on PE-A LSR device. The engineer must ensure there are no LDP peer are fully operational. Which LDP feature must the engineer apply to the existing configuration to eliminate the problem?
Question 177

After implement MPLS protocol for multiple VRFs on a single Cisco device, the engineer notices all VRFs on the router still do to not LDP session protection feature enabled. Which configuration must the engineer apply to enable the LDP session protection feature FOR LDP neighbors within each VRF?
Question 178

Refer to the exhibit.
An engineer is securing a customer's network. Which command completes this configuration and the engineer must use to prevent a DoS attack?
Question 179

Refer to the exhibit.
An engineer working for private Service Provider with employee id: 3948:11:613 is configuring the BGPsec framework. Which two conditions must the engineer take into account? (Choose two.)
Question 180

Which characteristic describes prefix segment identifier?
Question