ExamGecko
Home / Cisco / 350-501 / List of questions
Ask Question

Cisco 350-501 Practice Test - Questions Answers, Page 19

List of questions

Question 181

Report Export Collapse

Refer to the exhibit.

Cisco 350-501 image Question 181 116463 10102024233011000000

An engineer configured BGP summarization on a customer's network. Which route is advertised to BGP peers?

192.0.0.0/16

192.0.0.0/16

192168.0.0/16

192168.0.0/16

192.168.1.0/24

192.168.1.0/24

192168.0.5/30

192168.0.5/30

Suggested answer: B
asked 10/10/2024
mohamad rachwani
38 questions

Question 182

Report Export Collapse

Refer to the exhibit.

Cisco 350-501 image Question 182 116464 10102024233011000000

An engineer is trying to implement BGP configuration on a router Which configuration error prevents the ASBR from establishing a BGP neighborship to a directly connected BGP speaker?

The routing policy is absent for this Cisco IOS XR eBGP instance.

The routing policy is absent for this Cisco IOS XR eBGP instance.

The IPv4 address family configuration under neighbor configuration-mode must be removed.

The IPv4 address family configuration under neighbor configuration-mode must be removed.

The VPNv4 address family interferes with the 8GP IPv4 address family negotiations.

The VPNv4 address family interferes with the 8GP IPv4 address family negotiations.

The TCP session parameters are not specified.

The TCP session parameters are not specified.

Suggested answer: D
Explanation:

https://www.cisco.com/c/en/us/td/docs/routers/xr12000/software/xr12k_r41/routing/configuration/guide/routing_cg41xr12k_chapter1.html

asked 10/10/2024
om Kumar
46 questions

Question 183

Report Export Collapse

Refer to the exhibit.

Cisco 350-501 image Question 183 116465 10102024233011000000

An engineer implemented OSPF neighbor relationship on an IOS device. Which configuration must be applied to get the OR/BOR election removed from interfaces running OSPF?

ip ospf network broadcast on interfaces running OSPF

ip ospf network broadcast on interfaces running OSPF

ip ospf network point-to-point on interfaces running OSPF

ip ospf network point-to-point on interfaces running OSPF

ip ospf network multipoint-point on interfaces running OSPF

ip ospf network multipoint-point on interfaces running OSPF

ip ospf network non-broadcast on n:erfaces running OSPF

ip ospf network non-broadcast on n:erfaces running OSPF

Suggested answer: B
asked 10/10/2024
Emmanuel Yeboah
43 questions

Question 184

Report Export Collapse

After a possible security breach, the network administrator of an ISP must verify the times that several different users logged into the network. Which command must the administrator enter to display the login time of each user that activated a session?

show netconf-yang sessions detail

show netconf-yang sessions detail

show netconf-yang datastores

show netconf-yang datastores

show platform software yang-management process

show platform software yang-management process

show netconf-yang sessions

show netconf-yang sessions

Suggested answer: A
Explanation:

https://www.cisco.com/c/en/us/td/docs/iosxml/ios/prog/configuration/167/b_167_programmability_cg/configuring_yang_datamodel.html

Cisco 350-501 image Question 184 explanation 116466 10102024233011000000

asked 10/10/2024
Peter Dunčko
44 questions

Question 185

Report Export Collapse

Refer to the exhibit.

Cisco 350-501 image Question 185 116467 10102024233011000000

Router R1 is reporting that its BGP neighbor adjacency to router R2 is down, but its state is Active as shown. Which configuration must be applied to routers R1 and R2 to fix the problem?


Cisco 350-501 image Question 185 Answer 1 116467 10102024233011000000


Cisco 350-501 image Question 185 Answer 1 116467 10102024233011000000


Cisco 350-501 image Question 185 Answer 2 116467 10102024233011000000


Cisco 350-501 image Question 185 Answer 2 116467 10102024233011000000


Cisco 350-501 image Question 185 Answer 3 116467 10102024233011000000


Cisco 350-501 image Question 185 Answer 3 116467 10102024233011000000


Cisco 350-501 image Question 185 Answer 4 116467 10102024233011000000


Cisco 350-501 image Question 185 Answer 4 116467 10102024233011000000

Suggested answer: C
asked 10/10/2024
Hamid Assimi
41 questions

Question 186

Report Export Collapse

Refer to the exhibit.

Cisco 350-501 image Question 186 116468 10102024233011000000

An engineer is configuring path selection on router R1 for two ASNs as shown. Which additional task must the engineer perform on Router 1 so that all outbound traffic utilizes the link between R1 and R3 to reach ASN 4567?

Configure a low weigh! on the peer to ASN 4567.

Configure a low weigh! on the peer to ASN 4567.

Configure a high weight on the peer to ASN 4567.

Configure a high weight on the peer to ASN 4567.

Configure an AS path prepend on the peer to ASN 4567.

Configure an AS path prepend on the peer to ASN 4567.

Configure a high med on the peer to ASN 4567.

Configure a high med on the peer to ASN 4567.

Suggested answer: B
asked 10/10/2024
Miguel Tuimil Galdo
43 questions

Question 187

Report Export Collapse

A network engineer is deploying VPLS configuration between multiple PE routers so that customer's remote offices have end-to-end LAN connectivity. Which additional configuration should the engineer perform on the PE routers to enable the virtual switch instance?


Cisco 350-501 image Question 187 Answer 1 116469 10102024233011000000


Cisco 350-501 image Question 187 Answer 1 116469 10102024233011000000


Cisco 350-501 image Question 187 Answer 2 116469 10102024233011000000


Cisco 350-501 image Question 187 Answer 2 116469 10102024233011000000


Cisco 350-501 image Question 187 Answer 3 116469 10102024233011000000


Cisco 350-501 image Question 187 Answer 3 116469 10102024233011000000


Cisco 350-501 image Question 187 Answer 4 116469 10102024233011000000


Cisco 350-501 image Question 187 Answer 4 116469 10102024233011000000

Suggested answer: B
Explanation:

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l2_vpns/configuration/xe-3s/mp-l2-vpnsxe-3s-book/mp-vpls.html#GUID-D5B09E97-F785-4BCD-91F7-8E7C7E5F5A04

asked 10/10/2024
MARTIN WEAVER
41 questions

Question 188

Report Export Collapse

A network operator needs to implement PIM-SSM multicast configuration on customer's network so that users in different domains are able to access and stream live traffic. Which two actions must the engineer perform on the network to make the streaming work? (Choose two.)

Configure at least one MSDP peer on the network

Configure at least one MSDP peer on the network

Enable IGMP version 2 at the interface lever.

Enable IGMP version 2 at the interface lever.

Enable PIM sparse mode on the device.

Enable PIM sparse mode on the device.

Enable IGMP version 3 at the interface level.

Enable IGMP version 3 at the interface level.

Enable PM dense mode on the device.

Enable PM dense mode on the device.

Suggested answer: A, D
asked 10/10/2024
Paola Aguirre
46 questions

Question 189

Report Export Collapse

Refer to the exhibit.

Cisco 350-501 image Question 189 116471 10102024233011000000

An engineer is implementing BGP selective prefix suppression. The router must advertise only 10.16.4.0/24,10.16.5.0/24. and summarized route 10.16.0.0/21. and suppress 10.16.6.0/24. Which configuration must the engineer apply to the router?


Cisco 350-501 image Question 189 Answer 1 116471 10102024233011000000


Cisco 350-501 image Question 189 Answer 1 116471 10102024233011000000


Cisco 350-501 image Question 189 Answer 2 116471 10102024233011000000


Cisco 350-501 image Question 189 Answer 2 116471 10102024233011000000


Cisco 350-501 image Question 189 Answer 3 116471 10102024233011000000


Cisco 350-501 image Question 189 Answer 3 116471 10102024233011000000


Cisco 350-501 image Question 189 Answer 4 116471 10102024233011000000


Cisco 350-501 image Question 189 Answer 4 116471 10102024233011000000

Suggested answer: B
asked 10/10/2024
Wisit Luasomboon
29 questions

Question 190

Report Export Collapse

Refer to the exhibit.

Cisco 350-501 image Question 190 116472 10102024233011000000

What does this REST API script configure?

application profile

application profile

VRF

VRF

public community string for SNMP

public community string for SNMP

interface with IP address 192.168.0.1

interface with IP address 192.168.0.1

Suggested answer: D
asked 10/10/2024
Oscar Ballabriga
35 questions
Total 448 questions
Go to page: of 45
Search

Related questions