Cisco 350-801 Practice Test - Questions Answers, Page 32
Question list
List of questions
Related questions
Which service on the Presence Server is responsible for maintaining the point-to-point chat connections between Jabber clients?
Cisco SIP Proxy
Cisco XCP Text Conference Manager
Cisco XCP Router
Cisco XCP XMPP Federation Manager
Which information is needed to restore the backup of a Cisco UCM publisher successfully?
the TFTP server details
the application credentials for Cisco UCM
the security password for Cisco UCM
the FTP server details
Which QoS marking is used when an administrator configures voice call signaling?
AF41
CS3
CS4
EF
Which value should be changed when each Cisco UCM node does not allow for more than 50phones to be registered?
Maximum Number of Registered and Unregistered Devices service parameter on each node
Minimum Number of Phones service parameter on each node
Maximum Number of Registered Devices service parameter on each node
Maximum Number of Phones service parameter on the Publisher
Which certificate does the Disaster Recovery System in Cisco UCM use to encrypt its communications?
Cisco Tomcat
CAPF
Cisco CallManager
IPsec
Which behavior occurs when Cisco UCM has a CallManager group that consists of two subscribers?
Endpoints attempt to register with the bottom subscriber in the list.
Endpoints attempt to register with the top subscriber in the list.
Endpoints attempt to register with both subscribers in a load-balanced method.
If a subscriber is rebooted, endpoints deregister until the rebooted system is back in service.
Refer to the exhibit.
Refer to the exhibit. An engineer configures ISDN on a voice gateway. The provider confirms that the PRI is configured with 10 channels the engineer ordered and is working from the provider side, but the engineer cannot get a B-channel to carry voice. The rest of the configuration for the serial interface and voice network is functioning correctly. Which actions must be taken to carry voice?
The engineer must activate the controller card on the voice gateway before configuring the device.
The engineer used a T1 interface but must use an E1 interface.
The pri-group timeslots command must be 0-9 for the 10 channels because all values on a router
start with 0.
The engineer must manually revert the order of using the channels.
When designing the capacity for a Cisco UCM 12.x cluster, an engineer must decide which VMware template will be used for each node. What is the lowest number of users supported in a template and the highest number of users in a template?
750 and 15.000 users
750 and 10.000 users
500 and 10.000 users
1000 and 10.000 users
When multiple potential patterns are present, which two things are considered when Cisco UCM selects a destination pattern? (Choose two.)
The pattern matches the shortest explicit prefix.
The pattern does not match the dialed string.
The pattern represents the smallest number of endpoints.
The pattern matches the dialed string.
The pattern represents the largest number of endpoints.
What is a characteristic of a SIP endpoint configured in Cisco UCM with ’Use Trusted Relay Point' setto "On’?
It creates a trust relationship with the called party.
It enables the Use Trusted Relay Point setting from the associated common device configuration.
It enables Cisco UCM to insert an MTP or transcoder designated as a TRP.
If TRP is allocated and MTP is also required for the endpoint. calls fail.
Question