What are two components that make up Juniper Networks' Session Smart Routing? (Choose two.)

Juniper Session Smart Conductor

Click the Exhibit button. After a series of outages in an existing network, you are asked to analyze and provide recommendations for resiliency for the data center network shown in the exhibit.Which improvement should you recommend to eliminate management plane single points of failure in this scenario?

Replace the Virtual Chassis with ESI-LAG from the leafs facing the servers.

Configure ESI-LAG on the spines facing the leafs.

Replace the Virtual Chassis with ESI-LAG from the leafs facing the servers.

Configure a Virtual Chassis between the spines.

Replace the Virtual Chassis with VRRP configured on the servers.

What is a design consideration for using IBGP for the underlay in a Clos data center fabric?

BGP ADD-PATH must be enabled for multipath to work on leafs.

A full mesh of IBGP neighbors will be required.

BGP ADD-PATH must be enabled for multipath to work on leafs.

An IGP will always be required for learning loopback addresses.

A 5-stage Clos topology will not work with IBGP underlay.

In an EVPN-VXLAN data center, what would be a reason to consider using discrete border leafs rather than placing border roles onto the spines?

to provide for differentiated oversubscription ratios for traffic into and out of the data center

to eliminate multicast traffic in and out of the fabric

to allow for provisioningACLs between the data center and the WAN

to provide specific devices designed for handlingtraffic burstiness on the WAN

Which two statements are correct about using BGP as the underlay routing protocol in an IP fabric? (Choose two.)

EBGP underlay requires the multipath multiple-as parameter with the corresponding load-balancing policy.

Route Reflection can be used in an IBGP underlay to increase control plane scalability.

Static routes are required for EBGP neighbors to establish.

EBGP underlay requires the multipath multiple-as parameter with the corresponding load-balancing policy.

Route Reflection can be used in an IBGP underlay to increase control plane scalability.

Using an IGP is required for an EBGP underlay.

Which statement is true about 3-stage IP fabrics?

Each leaf node must have at least one physical connection to each spine node.

There must be physical connections between all of the spine nodes.

Each leaf node must have at least one physical connection to each spine node.

There must be physical connections between all of the leaf nodes.

Each leaf node must have at least two physical connections to each spine node.

When determining the oversubscription ratio for an IP fabric, which two statements are true? (Choose two.)

Removing spine nodes from the IP fabric increases the oversubscription ratio.

Adding spine nodes to the IP fabric decreases the oversubscription ratio.

Removing spine nodes from the IP fabric increases the oversubscription ratio.

Removing leaf nodes from the IP fabric increases the oversubscription ratio.

Adding spine nodes to the IP fabric decreases the oversubscription ratio.

Adding leaf nodes to the IP fabric decreases the oversubscription ratio.

Which two statements correctly describe an ESI-LAG? (Choose two.)

Both VTEPs advertise connectivity to the same Ethernet segment.

The LACP system ID on the two connected leafs is configured with the same value.

Both VTEPs advertise connectivity to the same Ethernet segment.

Both VTEPs advertise connectivity to different Ethernet segments.

The LACP system ID on the two connected leafs is configured with the same value.

The LACP system ID on the two connected leafs is configured with different values.

You are considering changing an IBGP-based IP fabric design to one that is EBGP-based.In this scenario, which two statements are correct about an EBGP-based design? (Choose two.)

Route reflection is not required.

Juniper JN0-1103 Practice Test 2 - Free Online Exam Prep & Questions

You are asked to create a proof of concept software-defined WAN (SD-WAN). You must identify its positive features for a project proposal.

Which two statements are correct in this scenario? (Choose two.)

Become a Premium Member for full access

Unlock Premium Member

Juniper JN0-1103 Practice Test 2

Question

Juniper JN0-1103 Practice Tests

Practice Tests