ExamGecko
Login
Home / Huawei / H12-261 / List of questions
Ask Question

Huawei H12-261 Practice Test - Questions Answers, Page 2

Add to Whishlist

List of questions

Question 11

Report Export Collapse

When a router is building a routing table from different routing protocols, which of the following will determine the routes to be installed in the routing table?

The fastest routing process
The fastest routing process
uniqueness
uniqueness
Higher preference value
Higher preference value
The route with the largest next-hop address
The route with the largest next-hop address
Low Router ID
Low Router ID
Suggested answer: C
asked 18/09/2024
Guillermo Fontaine
56 questions

Question 12

Report Export Collapse

Which of the following statements are NOT true regarding the TCP sliding window protocol? (Multiple Choice)

The initial window offer is advertised by the sender
The initial window offer is advertised by the sender
If the retransmission timer expires without the sender receiving an ACK message, the receiver retransmits the packet to the sender.
If the retransmission timer expires without the sender receiving an ACK message, the receiver retransmits the packet to the sender.
The size of the sliding window can only increase or stay the same
The size of the sliding window can only increase or stay the same
It allows the transmission of multiple frames before waiting for an acknowledgment
It allows the transmission of multiple frames before waiting for an acknowledgment
The receiver is required to acknowledge the data packets transmitted by the sender
The receiver is required to acknowledge the data packets transmitted by the sender
The sender need not transmit a full window's worth of data
The sender need not transmit a full window's worth of data
Suggested answer: A, B, E, F
asked 18/09/2024
Adrian Mark
36 questions

Question 13

Report Export Collapse

Routers R1 and R2 are configured for BGP. Both routers are in AS 65234. Routes from Router R2 are in the BGP table on Router R1, but not in the IP routing table. What could be the cause of this problem?

Synchronization is off
Synchronization is off
BGP multi-hop is disabled on Router R1
BGP multi-hop is disabled on Router R1
The next-hop of these routes can not reach by router R1
The next-hop of these routes can not reach by router R1
The BGP peers are down
The BGP peers are down
Suggested answer: C
asked 18/09/2024
Gurdeep Girn
38 questions

Question 14

Report Export Collapse

What is the destination IP address of routing update packets sent by RIPv2?

255.255.255.255
255.255.255.255
224.0.0.1
224.0.0.1
224.0.0.5
224.0.0.5
224.0.0.9
224.0.0.9
224.0.0.10
224.0.0.10
Suggested answer: D
asked 18/09/2024
ALAEDDINE BENMAKHLOUF
54 questions

Question 15

Report Export Collapse

The LS Sequence Number field is used to detect expired and duplicate LSAs. This field is a signed 32-bit integer and therefore the minimum LS Sequence

Number is 0x800000000.

FALSE
FALSE
TRUE
TRUE
Suggested answer: A
asked 18/09/2024
Praveen Achankunju
49 questions

Question 16

Report Export Collapse

Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is not configured as a route reflector?

Prefixes received from EBGP peers and prefixes received from route reflectors
Prefixes received from EBGP peers and prefixes received from route reflectors
All prefixes in its routing table
All prefixes in its routing table
Prefixes received from EBGP peers and prefixes locally originated via network statements or imported
Prefixes received from EBGP peers and prefixes locally originated via network statements or imported
Prefixes received from other IBGP peers, prefixes received from EBGP peers, and prefixes imported to BGP
Prefixes received from other IBGP peers, prefixes received from EBGP peers, and prefixes imported to BGP
Prefixes received from other IBGP peers and prefixes received from router reflectors
Prefixes received from other IBGP peers and prefixes received from router reflectors
Prefixes received from any other BGP peer and prefixes locally originated via network statements or imported
Prefixes received from any other BGP peer and prefixes locally originated via network statements or imported
Suggested answer: C
asked 18/09/2024
Jose Manuel GONZALEZ BALSEIRO
41 questions

Question 17

Report Export Collapse

In a data communication session between two hosts, the session layer in the OSI model generally communicates with what other layer of the OSI model?

The physical layer of the peer
The physical layer of the peer
The peer's presentation layer
The peer's presentation layer
The peer's session layer
The peer's session layer
The peer's application layer
The peer's application layer
The data link layer of the peer
The data link layer of the peer
Suggested answer: C
asked 18/09/2024
Rocco Cristofaro
51 questions

Question 18

Report Export Collapse

If a router receives a BGP route carrying the no-export community attribute, which of the following actions does the router take?

Does not advertise the route to other BGP routers
Does not advertise the route to other BGP routers
Discards the route directly
Discards the route directly
Advertises the route to IBGP peers only
Advertises the route to IBGP peers only
Advertises the route normally, but does not use it to forward data
Advertises the route normally, but does not use it to forward data
Suggested answer: C
asked 18/09/2024
Higher System Consultancy
48 questions

Question 19

Report Export Collapse

As shown in the following figure, the neighbor relationship between R1 and R2 has just been established. Which of the following statements is true about the database synchronization process between R1 and R2?

Huawei H12-261 image Question 19 32041 09182024192157000000

The packet sent from R1 and R2 is a PSNP packet
The packet sent from R1 and R2 is a PSNP packet
The packet sent from R1 and R2 is a Hello packet
The packet sent from R1 and R2 is a Hello packet
The packet sent from R1 and R2 is a CSNP packet
The packet sent from R1 and R2 is a CSNP packet
The packet sent from R1 and R2 is a LSP packet
The packet sent from R1 and R2 is a LSP packet
Suggested answer: A
asked 18/09/2024
Sai Janani Ravishankar
39 questions

Question 20

Report Export Collapse

Which of the following are key differences between RIP version 1 and RIP version 2? (Multiple Choice)

RIP version 2 uses multicasts while RIP version 1 does not
RIP version 2 uses multicasts while RIP version 1 does not
RIP version 1 supports authentication while RIP version 2 does not
RIP version 1 supports authentication while RIP version 2 does not
RIP version 1 does not support VLSM while RIP version 2 does
RIP version 1 does not support VLSM while RIP version 2 does
RIP version 1 is distance vector while RIP version 2 is not
RIP version 1 is distance vector while RIP version 2 is not
RIP version 1 uses hop counts as the metric while RIP version 2 uses bandwidth information
RIP version 1 uses hop counts as the metric while RIP version 2 uses bandwidth information
Suggested answer: A, C
asked 18/09/2024
taheireem shaikh
41 questions
Total 298 questions
Go to page: of 30
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Which of the following statements regarding CE dual-homing features is false?
Which packet type is used when BGP EVPN is used to establish VXLAN tunnels?
Subnets of one subnet is as follows: RT=10:10 both and TR=1000:1000 export in the EVPN instance and RT=100:100 in the VPN instance. Which of the following configurations can be made for another subnet?
Which of the following statements regarding Filter-policy is true?
Which of the following statements regarding the stub area and NSSA in OSPF is false?
Which of the following AS-_Path attribute values can be matched by the AS-Path filter configured using ip as-path filter 1 permit .*(100|400$command?
The VRRP priority cannot be set to 0, so the device that sends a VRRP packet with priority 0 stops participating in the VRRP group and notifies the backup device to become the master device right away, without waiting for the Master_Down_Interval timer to expire?
The Next Header field only exists in the basic header of an IPv6 packet, and its function is only to indicate whether the IPv6 packet has an extension header.
Assume that BGP/MPLS IPv4 VPN configured with OSPF, LDP, and static routing has been deployed on a PE router. To enable the NSF function, which of the following protocols need to be configured to enable the GR function on the PE router?
On router HW1, you want to view the status of a frame relay connection. Which "display" commands will show the status of a Frame-Relay PVC? (Multiple choice)