When will the bypass module of Huawei integrated UPS to start to work?

The UPS works in ECO mode, and the bypass voltage is within the preset range.

Both the active and standby ECMs are abnormal.

The power module overload times out.

The UPS works in ECO mode, and the bypass voltage is within the preset range.

The UPS is lust powered on and the inverter is not started.

The power system of a UPS2000-G-15K at a site is three-phase input and single-phase output. After installation, it is found that the mains and bypass inputs are three-phase, the output is single-phase, and the mains and bypass inputs share a power source. Which of the following statements are true about the UPS wiring mode?

The wiring mode is incorrect, if the upstream mains input switch is turned on, the UPS will be short-circuited and damaged immediately.

The wiring mode is correct. The UPS can start properly.

The wiring mode is incorrect. The UPS cannot work in battery mode, but can still work in bypass mode or inverter mode.

The wiring mode is incorrect. The correct wiring mode should be single-phase bypass input, three-phase mains input, and one power source.

Fill the pipe with high-pressure nitrogen.

Quickly remove the pipe plug, and avoid facing people to prevent injury.

To discharge nitrogen from the outdoor unit.

The maximum batten/ charge current is 0.1C10.

The batten/ charge current is always 0.1C10.

The battery float charge current is 0.1C10.

The maximum battery charge current is 0.1C10.

Which of the following is a standard component in the FusionModule800 typical configuration?

Become a Premium Member for full access