Home / Juniper / JN0-363

Juniper JN0-363 Practice Test - Questions Answers, Page 5

Question list

List of questions

Question 41

(0)

You want to enable a routing platform with redundant REs to switch from a primary RE to a backup RE without alerting peer nodes. Which two technologies would you use to satisfy this requirement? (Ch

Question 42

(0)

Exhibit Which type of load balancing is shown in the exhibit?

Question 43

(0)

Exhibit Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)

Question 44

(0)

You have created a routing instance named vr3 that will provide access to Server 2 (10.0.0.2) (or the hosts on the 10.10.10.0/24 network. Which command would you use to test connectivity between vr3

Question 45

(0)

Exhibit Routers R1 and R4 have a VRRP priority of 90, while R2 and R3 have default VRRP priorities Referring to the exhibit, which router will be elected as the primary VRRP router?

Question 46

(0)

Exhibit Referring to the exhibit, what will happen to untagged frames?

Question 47

(0)

Exhibit Referring to the exhibit, internal BGP between R1 and R2 is not establishing. What is the problem In this scenario?

Question 48

(0)

Exhibit Referring to the exhibit, which two additional steps should you lake to fully configure NSR? (Choose two.)

Question 49

(0)

Exhibit You have configured graceful RE switchover (GRES), however you cannot complete the show system switchover command. Referring to the exhibit, what is the problem?

Question 50

(0)

Which BGP attribute Is used to detect touting loops?

Question 41

You want to enable a routing platform with redundant REs to switch from a primary RE to a backup RE without alerting peer nodes. Which two technologies would you use to satisfy this requirement? (Choose two.)

GRES

VRRP

NSR

ISSU

Show Answer Comment (0)

Question 42

Exhibit

Which type of load balancing is shown in the exhibit?

elastic load balancing

per-packet load balancing

per-flow load balancing

network load balancing

Show Answer Comment (0)

Question 43

Exhibit

Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)

R3 is considered a P router.

R3 is considered a PE router.

R3 is considered a transit router.

R3 is considered an ingress router.

Show Answer Comment (0)

Question 44

You have created a routing instance named vr3 that will provide access to Server 2 (10.0.0.2) (or the hosts on the 10.10.10.0/24 network. Which command would you use to test connectivity between vr3 and Server 2?

user@vr3> ping 10.0.0.2 count 5

user@vr3> ping 10.0.0.2 count 5 source 10.10.10.1

user9router1> ping 10.0.0.2 count 5

user@router1> ping 10.0.0.2 routing-instance vr3 count 5

Show Answer Comment (0)