Juniper JN0-649 Practice Test - Questions Answers

Referring to the exhibit, anycast RP is implemented to ensure multicast service availability. The source is currently sending multicast traffic using group 239.1.1.1 and R3 is receiving PIM register messages, but R2 does not have active source information.

In this scenario, what are two methods to receive the active source information on R2? (Choose two.)

You are asked to establish interface level authentication for users connecting to your network. You must ensure that only corporate devices, identified by MAC addresses, are allowed to connect and authenticate. Authentication must be handled by a centralized server to increase scalability.

Which authentication method would satisfy this requirement?

Referring to the exhibit, which LSA type is used to advertise 192.168.1.0/24 to R5?

You enable the Multiple VLAN Registration Protocol (MVRP) to automate the creation and management of virtual LANs.

Which statement is correct in this scenario?

Which address range is used for source-specific multicast?

Which three configuration parameters must match on all switches within the same MSTP region?

(Choose three.)

Which two statements are correct about the deployment of EVPN-VXLAN on QFX Series devices?

(Choose two.)

Your enterprise network is running BGP VPNs to support multitenancy. Some of the devices with which you peer BGP do not support the VPN NLRI. You must ensure that you do not send BGP VPN routes to the remote peer.

Which two configuration steps will satisfy this requirement? (Choose two.)

You want to create an OSPF area that only contains intra-area route information in the form of Type 1 and Type 2 LSAs.

In this scenario, which area is needed to accomplish this task?