Juniper JN0-649 Practice Test - Questions Answers, Page 6

You are asked to configure 802.1X on your access ports to allow only a single device to authenticate.

In this scenario, which configuration would you use?

Referring to the exhibit, which two statements are correct? (Choose two.)

You are asked to establish full connectivity between all devices in the BGP network.

Referring to the exhibit, which two configuration changes will allow BGP route advertisements?

(Choose two.)

Referring to the exhibit, which two statements are correct? (Choose two.)

You are deploying an 802.1X solution and must determine what would happen if clients are unable to re-authenticate to the RADIUS server.

In this scenario, which configuration would provide access to the network if the supplicant is already authenticated?

You are deploying IP phones in your enterprise network that must receive their power through their Ethernet connection. You are using your EX Series switch's PoE ports that support IEEE 802.3af.

In this scenario, what is the maximum amount of power allocated to each interface?

You are deploying IP phones in your enterprise networks. When plugged in, the IP phones must be automatically provided with the correct VLAN ID needed for sending voice traffic to the EX Series switches.

In this scenario, which two solutions are required to accomplish this task? (Choose two.)

Referring to the exhibit, how will router E quickly learn that the remote MAC addresses are no longer reachable through the router attached to the failed link?

Referring to the exhibit, which statement is correct?