Network Appliance NS0-520 Practice Test - Questions Answers, Page 17

List of questions
Question 161

You are booting a NetApp storage system for the first time. In which order should the various components be powered on?
Question 162

When booting your NetApp storage system for the first time the system fails to boot.
What should you do first to address this problem?
Question 163

After completing the configuration of a new Brocade Fibre Channel switch, which command do you use to verify your configuration?
Question 164

Which native GUI switch tool is used to manage Cisco MDS-Series switches and directors?
Question 165

Which configuration for primary block (FC and iSCSI) data does NetApp best practices recommend?
(Choose two.)
Question 166

When running diagnostic tests after an initial installation of a NetApp FAS3000 storage system, which command is used to run a comprehensive set of diagnostic tests on the entire system?
Question 167

You are about to replace a failed Brocade Fibre Channel switch. Which three steps do you take prior to connecting the switch in the SAN? (Choose three.)
Question 168

At which storage object level is deduplication enabled?
Question 169

Which commands allow you to enable NetApp deduplication and verify space savings?
Question 170

Which row of items should you look up in the IMT (Interoperability Matrix Tool) when designing a NetApp Storage Solution for a customer?
Question