ExamGecko
Search Search Login
Home Home / Cisco / 300-515
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

You try to configure MPLS VPN VRF Selection based on a source IP address on an interface that has VRF configured, but you receive an error. Which action must you take to correct the problem?
Refer to the exhibit. PE1 and PE2 are exchanging VPNv4 routes for CE1 and CE2, and PE3 contains the default route to the internet. If the three devices are operating normally, which two conclusions describe this configuration? (Choose two.)
Refer to the exhibit. Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?
A network architect is troubleshooting the L2TPv3 tunneling security due to the untrusted nature of the underlaying network. Which two L2TPv3 features does the architect deploy to address the ongoing issues? (Choose two.)
An engineer is troubleshooting AToM on an IOS XE router and receives an error when creating the xconnect. Which command does he need to complete to create the xconnect in AToM?
An engineer needs to improve MPLS network management by implementing a set of tools to support the NOC engineers in troubleshooting network failures. Which feature should the engineer implement to check the connectivity of the MPLS LSP between the ingress and egress PE routers?
Which two frames can be configured on an Ethernet flow point? (Choose two.)
In an Ethernet Virtual Circuit environment, which restriction do bridge domains have when STP is running?
Refer to the exhibit. Which statement describes the result of this BGP configuration?
You are writing the requirements for an MPLS L3VPN environment that uses MP-BGP between PE routers. In this environment, route targets and route distinguishers need to be advertised between the PE routers. Which three operations meet these requirements? (Choose three.)

Question 4 - 300-515 discussion

Report
Export


Refer to the exhibit. A network engineer has been called to configure the four PE devices in order to enable full communication among the four CE devices connected to them. While starting to configure, he experienced a connectivity issue.

Which two tasks should the engineer perform in order to begin the process correctly? (Choose two.)

A.

Configure PE3 to export route-targets 100:1 and 200:2. B. Configure PE3 to import route-targets 100:1 and 200:2.

Answers
A.

Configure PE3 to export route-targets 100:1 and 200:2. B. Configure PE3 to import route-targets 100:1 and 200:2.

B.

Configure PE4 to import route-targets 101:1 and 202:2. D. Configure PE2 to export route-targets 300:3 and 400:4.

Answers
B.

Configure PE4 to import route-targets 101:1 and 202:2. D. Configure PE2 to export route-targets 300:3 and 400:4.

C.

Configure PE1 to import route-targets 300:3 and 400:4.

Answers
C.

Configure PE1 to import route-targets 300:3 and 400:4.

Suggested answer: A, B
Show Answer
asked 07/10/2024
Ali Reza Azmi
43 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms