ExamGecko
Search Search Login
Home Home / Cisco / 300-515
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

You try to configure MPLS VPN VRF Selection based on a source IP address on an interface that has VRF configured, but you receive an error. Which action must you take to correct the problem?
Refer to the exhibit. PE1 and PE2 are exchanging VPNv4 routes for CE1 and CE2, and PE3 contains the default route to the internet. If the three devices are operating normally, which two conclusions describe this configuration? (Choose two.)
Refer to the exhibit. Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?
A network architect is troubleshooting the L2TPv3 tunneling security due to the untrusted nature of the underlaying network. Which two L2TPv3 features does the architect deploy to address the ongoing issues? (Choose two.)
An engineer is troubleshooting AToM on an IOS XE router and receives an error when creating the xconnect. Which command does he need to complete to create the xconnect in AToM?
Which two frames can be configured on an Ethernet flow point? (Choose two.)
An engineer needs to improve MPLS network management by implementing a set of tools to support the NOC engineers in troubleshooting network failures. Which feature should the engineer implement to check the connectivity of the MPLS LSP between the ingress and egress PE routers?
In an Ethernet Virtual Circuit environment, which restriction do bridge domains have when STP is running?
Refer to the exhibit. Which statement describes the result of this BGP configuration?
You are writing the requirements for an MPLS L3VPN environment that uses MP-BGP between PE routers. In this environment, route targets and route distinguishers need to be advertised between the PE routers. Which three operations meet these requirements? (Choose three.)

Question 44 - 300-515 discussion

Report
Export


Refer to the exhibit. The CE router has established a BGP peering with the PE router, and the CE will use the core infrastructure of the PE as a backbone carrier to support CSC. Which additional task can you perform to complete the configuration?

A.

Configure static routing on the CE router.

Answers
A.

Configure static routing on the CE router.

B.

Configure the address-family ipv4 labeled-unicast command under the neighbor configuration of the CE router for the PE.

Answers
B.

Configure the address-family ipv4 labeled-unicast command under the neighbor configuration of the CE router for the PE.

C.

Change the rd value to 65001:65001 under the VRF section of the PE router.

Answers
C.

Change the rd value to 65001:65001 under the VRF section of the PE router.

D.

Configure OSPF on the PE router.

Answers
D.

Configure OSPF on the PE router.

Suggested answer: D
Show Answer
asked 07/10/2024
ACHILLE CARROLL
43 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms