Home

Home / Cisco / 300-615

Question list

List of questions

Question 1

(0)

A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)

Question 2

(0)

A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which

Question 3

(0)

Refer to the exhibit. After a failover occurs, which two actions must be performed on Switch-B to manually preempt the operational primary role back to Switch-A? (Choose two.)

Question 4

(0)

Refer to the exhibit. An OSPF adjacency between Router-A and Router-B cannot reach the FULL state. Which action resolves the issue?

Question 5

(0)

The Cisco Nexus switch is connected to a peer switch that is not running Cisco NX-OS. The switches are connected using port channel and are experiencing packet loss. Which action should be performed

Question 6

(0)

Refer to the exhibit. The HSRP configuration in the exhibit fails to function. Which action resolves this issue?

Question 7

(0)

Refer to the exhibit. The HSRP instance on both switches is showing as active. Which action resolves the issue?

Question 8

(0)

An engineer is troubleshooting a fabric discovery failure. Which two requirements must an engineer verify about switch connectivity to solve the problem? (Choose two.)

Question 9

(0)

Refer to the exhibit. A network engineer has connected the Nexus switch management port to the Internet using DHCP to allow the Guest shell running on the switch to download Python packages. The

Question 10

(0)

Refer to the exhibit. vPC between switch1 and switch2 is not working. Which two actions are needed to fix the problem? (Choose two.)

Open VPLUS File

Convert VPLUS to PDF

Related questions

Refer to the exhibit. A network engineer is implementing an RBAC on the Cisco Nexus 9000 Series Switch. The role called Host A fails to clear LACP counters on the port channel 20. Which configuration resolves the issue?

The VXL AN fabric is deployed with this configuration: - The VL AN 50 interface has no IP address on VTEP1 and VTEP4. - The VLAN 100 interface has no IP address on VTEP2 and VTEP3. - nve1 interface is configured on all VTEPs. Host A experiences timeouts when attempting to ping host B. Which set of actions allows host A to reach host B7 A. On VTEP1, associate VNI 30000 to Test_ Telco VRF. On VTEP4, associate VNI 20000 to Test_ Telco VRF.

DRAG DROP Drag each item listed on the left to its proper category on the right Not all items will fit the categories.

Refer to the exhibit. An engineer is configuring boot from iSCSI on a Cisco UCS B-Series Blade Server, but the LUN fails to mount. Which action resolves the issue?

A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)

Refer to the exhibit. Refer to the exhibit. A functioning trunk port Ethernet1/48 exists between two identical Cisco Nexus 5000 Series Switches. The interfaces on the switches support the MACsec feature and are configured identically. To enable manual MACsec, an engineer adds the configuration shown in the exhibit to both sides of the trunk. The trunk port stops functioning. Which action should be taken to resolve the issue?

Refer to the exhibit. The FCoE traffic fails to traverse the vfc2 interface. The VSAN 102 is configured for vfc2. Which action resolves the issue?

DRAG DROP A Cisco Nexus 9000 Series Switch crashes and fails to boot. An engineer must recover the switch and investigate the issue. The switch uses 172.20.50.213/24 IP address for management and its default gateway is 172.20.50.254. Drag and drop the steps for recovering the Cisco Nexus 9000 Series Switch from the left onto the right. Not all steps are used.

Refer to the exhibit. A recent configuration change removes the HSRP adjacency between the SW-1 and SW-2 Cisco Nexus switches. The change causes the servers on this subnet to lose Internet access. Which action restores the connectivity of all servers on VLAN 13?

Refer to the exhibit. The EEM script overrides all events in the system policy. What should be added to the script to resolve the issue?

Question 6 - 300-615 discussion

Report

Refer to the exhibit.

The HSRP configuration in the exhibit fails to function. Which action resolves this issue?

A.

Enable IP redirects.

B.

Set the MTU to 1500 bytes.

C.

Configure HSRP version 2.

D.

Configure the same HSRP group on both devices.

Show Answer

asked 07/10/2024

Steve Nihan

39 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first