ExamGecko
Search Search Login
Home Home / Cisco / 300-615
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. A network engineer is implementing an RBAC on the Cisco Nexus 9000 Series Switch. The role called Host A fails to clear LACP counters on the port channel 20. Which configuration resolves the issue?
Refer to the exhibit. Refer to the exhibit. A functioning trunk port Ethernet1/48 exists between two identical Cisco Nexus 5000 Series Switches. The interfaces on the switches support the MACsec feature and are configured identically. To enable manual MACsec, an engineer adds the configuration shown in the exhibit to both sides of the trunk. The trunk port stops functioning. Which action should be taken to resolve the issue?
The VXL AN fabric is deployed with this configuration: - The VL AN 50 interface has no IP address on VTEP1 and VTEP4. - The VLAN 100 interface has no IP address on VTEP2 and VTEP3. - nve1 interface is configured on all VTEPs. Host A experiences timeouts when attempting to ping host B. Which set of actions allows host A to reach host B7 A. On VTEP1, associate VNI 30000 to Test_ Telco VRF. On VTEP4, associate VNI 20000 to Test_ Telco VRF.
DRAG DROP Drag each item listed on the left to its proper category on the right Not all items will fit the categories.
Refer to the exhibit. An engineer is configuring boot from iSCSI on a Cisco UCS B-Series Blade Server, but the LUN fails to mount. Which action resolves the issue?
A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)
Refer to the exhibit. The FCoE traffic fails to traverse the vfc2 interface. The VSAN 102 is configured for vfc2. Which action resolves the issue?
Refer to the exhibit. The EEM script overrides all events in the system policy. What should be added to the script to resolve the issue?
DRAG DROP A Cisco Nexus 9000 Series Switch crashes and fails to boot. An engineer must recover the switch and investigate the issue. The switch uses 172.20.50.213/24 IP address for management and its default gateway is 172.20.50.254. Drag and drop the steps for recovering the Cisco Nexus 9000 Series Switch from the left onto the right. Not all steps are used.
Refer to the exhibit. A recent configuration change removes the HSRP adjacency between the SW-1 and SW-2 Cisco Nexus switches. The change causes the servers on this subnet to lose Internet access. Which action restores the connectivity of all servers on VLAN 13?

Question 159 - 300-615 discussion

Report
Export

Refer to the exhibit.

Refer to the exhibit. A network engineer must use BGP to route IPv4 and IPv6 routes between R1 and R2. The IPv4 addresses are exchanged as expected between the routers through BGP. The routers have reached an Established BGP state. However, the IPv6 routes from R2 fail to show in the routing table of R1. Which action resolves the issue?

A.

Create a route map that sets the IPv6 next hop.

Answers
A.

Create a route map that sets the IPv6 next hop.

B.

Advertise L2VPN EVPN under IPv4 unicast address family

Answers
B.

Advertise L2VPN EVPN under IPv4 unicast address family

C.

Configure an IPv6 BGP neighbor on R1

Answers
C.

Configure an IPv6 BGP neighbor on R1

D.

Enable IPv6 routing on R1

Answers
D.

Enable IPv6 routing on R1

Suggested answer: A
Show Answer
asked 07/10/2024
Christian Weber
33 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms