Home

Home / CWNP / CWAP-404

Question list

List of questions

Question 1

(0)

Which one of the following is required for Wi-Fi integration in laptop-based Spectrum Analyzer software in addition to the spectrum analysis adapter?

Question 2

(0)

You're the WLAN administrator for a large retailer based at the HQ in New York. The London-based office has been complaining about WLAN disconnections around lunch time each day. You suspect this mi

Question 3

(0)

What is encrypted within the third message of the 4-Way Handshake?

Question 4

(0)

How many frames are exchanged for 802.11 authentication in the 6 GHz band when WPA3-Enterprise is not used, and a passphrase is used instead?

Question 5

(0)

As a wireless network consultant you have been called in to troubleshoot a high-priority issue for one of your customers. The customer's office is based on two floors within a multi-tenant office bl

Question 6

(0)

During a VHT Transmit Beamforming sounding exchange, the beamformee transmits a Compressed Beamforming frame to the beamformer. What is communicated within this Compressed Beamforming frame?

Question 7

(0)

ABC International has installed a new smart ZigBee controlled lighting system. However, the network team is concerned that this new system will interfere with the existing WLAN and has asked you to

Question 8

(0)

In a Spectrum Analyzer the Swept Spectrogram plot displays what information?

Question 9

(0)

You have installed a new 802.1 lac WLAN configured with 80 MHz channels. Users in one area are complaining about poor performance. This area is currently served by a single AP. You take a spectrum a

Question 10

(0)

Which one of the following should be the first step when troubleshooting a WLAN issue?

Open VPLUS File

Convert VPLUS to PDF

Related questions

Finish the statement: It is possible to distinguish between_______22 MHz transmissions and________20 MHz transmissions when looking at an FFT plot.

When performing protocol analysis, you capture an 802.1 lac data frame on channel 52, transmitted at MCS 8. At what data rate was the PHY Preamble transmitted?

You have installed a new 802.1 lac WLAN configured with 80 MHz channels. Users in one area are complaining about poor performance. This area is currently served by a single AP. You take a spectrum analysis capture in the poor performing are a. While examining the waterfall plot you notice the airtime utilization is higher on the first 20 MHz of the 80 MHz channel when compared to the rest of the channel. What do you conclude?

You are troubleshooting a client that is experiencing slow WLAN performance. As part of the troubleshooting activity, you start a packet capture on your laptop close to the client device. While analyzing the packets, you suspect that you have not captured all packets transmitted by the client. By analyzing the trace file, how can you confirm if you have missing packets?

After examining a Beacon frame decode you see the SSID Element has a length of 0. What do you conclude about this frame?

You're the WLAN administrator for a large retailer based at the HQ in New York. The London-based office has been complaining about WLAN disconnections around lunch time each day. You suspect this might be interference from the staff microwave, how might you test your theory from the New York office?

Why would a STA that supports 802.11k Radio Measurement send a Neighbor Request to an AP?

How many frames make up the Group Key Handshake excluding any Ack frames that may be required?

When performing protocol analysis, you notice a high number of RTS/CTS frames being transmitted on an HT network. You suspect this may be due to HT protection mechanisms. Where in the Beacon frame would you look to determine which one of the four HT protection modes the AP is operating in?

What is the difference between a Data frame and a QoS-Data frame?

Question 47 - CWAP-404 discussion

Report

Where, in a protocol analyzer, would you find an indication that a frame was transmitted as part of an A-MPDU?

A.

The HT Operation Element

B.

A-MPDU flag in the QoS Control Field

C.

A-MPDU flag in the Frame Control Field

D.

The Aggregation flag in the Radio Tap Header

Show Answer

asked 16/09/2024

Ronald DeCastro

32 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first