ExamGecko
Search Search Login
Home Home / Fortinet / NSE7_EFW-7.2
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit, which shows two configured FortiGate devices and peering over FGSP. The main link directly connects the two FortiGate devices and is configured using the set session-syn-dev <interface> command. What is the primary reason to configure the main link?
Exhibit. Refer to the exhibit, which contains a partial policy configuration. Which setting must you configure to allow SSH?
Which, three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)
Which FortiGate in a Security I auric sends togs to FortiAnalyzer?
Exhibit. Refer to the exhibit, which shows information about an OSPF interlace What two conclusions can you draw from this command output? (Choose two.)
Which two statements about metadata variables are true? (Choose two.)
Which two statements about IKE vision 2 are true? (Choose two.)
Refer to the exhibits, which contain the network topology and BGP configuration for a hub. Exhibit A. Exhibit B. An administrator is trying to configure ADVPN with a hub and spoke VPN setup using iBGP. All the VPNs are up and connected to the hub. The hub is receiving route information from both spokes over iBGP; however the spokes are not receiving route information from each other. What change must the administrator make to the hub BGP configuration so that the routes learned from one spoke are forwarded to the other spoke?
Refer to the exhibit. which contains a partial configuration of the global system. What can you conclude from this output?
Refer to the exhibit, which shows a network diagram. Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Question 7 - NSE7_EFW-7.2 discussion

Report
Export

Refer to the exhibit, which shows an ADVPN network.

Which VPN phase 1 parameters must you configure on the hub for the ADVPN feature to function? (Choose two.)

A.
set auto-discovery-forwarder enable
Answers
A.
set auto-discovery-forwarder enable
B.
set add-route enable
Answers
B.
set add-route enable
C.
set auto-discovery-receiver enable
Answers
C.
set auto-discovery-receiver enable
D.
set auto-discovery-sender enable
Answers
D.
set auto-discovery-sender enable
Suggested answer: A, C

Explanation:

For the ADVPN feature to function properly on the hub, the following phase 1 parameters must be configured:

A) set auto-discovery-forwarder enable: This enables the hub to forward shortcut information to the spokes, which is essential for them to establish direct tunnels.

C) set auto-discovery-receiver enable: This allows the hub to receive shortcut offers from the spokes.

This information is corroborated by the Fortinet documentation, which explains that in an ADVPN setup, the hub must be able to both forward and receive shortcut information for dynamic tunnel creation between spokes.

Show Answer
asked 18/09/2024
Fahim Thanawala
43 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms