Home

Home / Fortinet / NSE7_EFW-7.2

Question list

List of questions

Question 1

(0)

Exhibit. Refer to the exhibit, which contains an active-active toad balancing scenario. During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate. What is

Question 2

(0)

Which two statements about IKE vision 2 are true? (Choose two.)

Question 3

(0)

Which statement about network processor (NP) offloading is true?

Question 4

(0)

Exhibit. Refer to exhibit, which shows a central management configuration Which server will FortiGate choose for web filler rating requests if 10.0.1.240 is experiencing an outage?

Question 5

(0)

Exhibit. Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices. Which two conclusions can you draw from this con figuration? (Choose two)

Question 6

(0)

Winch two statements about ADVPN are true? (Choose two)

Question 7

(0)

Refer to the exhibit, which shows an ADVPN network. Which VPN phase 1 parameters must you configure on the hub for the ADVPN feature to function? (Choose two.)

Question 8

(0)

Refer to the exhibit, which shows an error in system fortiguard configuration. What is the reason you cannot set the protocol to udp in config system fortiguard?

Question 9

(0)

Refer to the exhibit, which contains information about an IPsec VPN tunnel. What two conclusions can you draw from the command output? (Choose two.)

Question 10

(0)

Refer to the exhibit, which contains a partial OSPF configuration. What can you conclude from this output?

Open VPLUS File

Convert VPLUS to PDF

Related questions

Refer to the exhibit, which shows two configured FortiGate devices and peering over FGSP. The main link directly connects the two FortiGate devices and is configured using the set session-syn-dev <interface> command. What is the primary reason to configure the main link?

Exhibit. Refer to the exhibit, which contains a partial policy configuration. Which setting must you configure to allow SSH?

Which, three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)

Which FortiGate in a Security I auric sends togs to FortiAnalyzer?

Exhibit. Refer to the exhibit, which shows information about an OSPF interlace What two conclusions can you draw from this command output? (Choose two.)

Refer to the exhibit. which contains a partial configuration of the global system. What can you conclude from this output?

Which two statements about metadata variables are true? (Choose two.)

Refer to the exhibit, which shows a network diagram. Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Which two statements about IKE vision 2 are true? (Choose two.)

Refer to the exhibits, which contain the network topology and BGP configuration for a hub. Exhibit A. Exhibit B. An administrator is trying to configure ADVPN with a hub and spoke VPN setup using iBGP. All the VPNs are up and connected to the hub. The hub is receiving route information from both spokes over iBGP; however the spokes are not receiving route information from each other. What change must the administrator make to the hub BGP configuration so that the routes learned from one spoke are forwarded to the other spoke?

Question 47 - NSE7_EFW-7.2 discussion

Report

Which ADVPN configuration must be configured using a script on fortiManager, when using VPN Manager to manage fortiGate VPN tunnels?

A.

Enable AD-VPN in IPsec phase 1

B.

Disable add-route on hub

C.

Configure IP addresses on IPsec virtual interlaces

D.

Set protected network to all

Show Answer

asked 18/09/2024

miquel martin leiva

42 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first