Home

Home / Huawei / H12-261

Question list

List of questions

Question 1

(0)

Router HW1 is seeing a large number of Discard Eligible (DE) frames. In Frame-relay, as part of the Congestion-Control Mechanism, the DE bit works in conjunction with which of the following mechanis

Question 2

(0)

Which parameter will not be received from the root bridge by a non-root bridge running 802.1D STP?

Question 3

(0)

Which of the following are used in Ethernet networks? (Multiple Choice)

Question 4

(0)

Which of the following statements is true about the port mirroring on Huawei devices?

Question 5

(0)

If a Gigabit Ethernet port receive buffer becomes full on a LAN switch, what protocol can be used to request that the remote port delay sending frames for a specified time?

Question 6

(0)

When receives or transmits data frames on an access port, what will the switch do?

Question 7

(0)

Spanning Tree Protocol calculates path cost based on which of the following?

Question 8

(0)

On router HW1, you want to view the status of a frame relay connection. Which "display" commands will show the status of a Frame-Relay PVC? (Multiple choice)

Question 9

(0)

HW has a Frame Relay network with two sites (a headquarters site and a remote site) connected by a single PVC. RIP version 2 is running in the network. A new remote site is added and HW has ordered

Question 10

(0)

Based on the preceding networking and configurations, which of the following statements is true?

Open VPLUS File

Convert VPLUS to PDF

Related questions

The default SSM group address range is 232.0.0.0/8. Which of the following configurations can be performed to modify the SSM group address range?

Which of the following AS-paths can be matched by the AS-Path filter configured using the ip as-path-filter 1 permit ^12.*74$ command?

For Huawei S series switches, to control which member switch becomes the master switch of a stack, first power on the switch you wish to be the master switch, and then wait 20 seconds before powering on the other member switches.

Which of the following command outputs indicates that a loop has occurred on a switch?

To reduce the amount of OSPF data and routing information in some areas, OSPF has special area types. Which of the following statements regarding OSPF special areas is true?

In the aggregate ipv4-address {mask | mask-length} [as-set | attribute-policy route-policy-name1 | detail-suppressed | origin-policy route-policy-name2 | suppress-policy route-policy-name3] command, multiple parameters can be used to affect the BGP summarized route and summarization result. Which of the following statements regarding this command are true?

Which of the following statements regarding the packet processing method in the MPLS network model are false?

Which of the following statements is true according to the topology shown?

Which parameter will not be received from the root bridge by a non-root bridge running 802.1D STP?

OSPF has been configured on R1 as shown above, but R1 does not learn the routes from any other routers, which of the following are possible causes? (Choose all that apply.)

Question 6 - H12-261 discussion

Report

When receives or transmits data frames on an access port, what will the switch do?

A.

Switch will send tagged frames belong to a specified vlan

B.

When received a tagged frame from an access port. Switch may forward it vlan

C.

Switch will learn the MAC-address only on access port

D.

Switch only receives untagged frames from access port and drop all tagged frames

Show Answer

asked 18/09/2024

Juan Contreras

36 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first