Home

Home / Juniper / JN0-363

Question list

List of questions

Question 1

(0)

You are asked to create connections between routing instances on the same Junos device and route between the connected Instances. What are two ways to accomplish this task? (Choose two.)

Question 2

(0)

Which configuration selling prohibits a static route from being redistributed by a dynamic routing protocol?

Question 3

(0)

Exhibit Which two statements are correct about the information shown in the exhibit? (Choose two.)

Question 4

(0)

Exhibit You are advertising a summary route that represents your local network (172.20.0.0716) to both ISP A and ISPB. You want to influence all traffic sent to you from ISP C to go through R2.

Question 5

(0)

Which two statements ate correct about the community BGP attribute on a Junos device? (Choose two.)

Question 6

(0)

Exhibit Referring to the exhibit, how do you verify the status of the tunnel from R1?

Question 7

(0)

You are asked to configure an LSP which uses the OSPF link state database for path computations. Which two statements are correct in this scenario? (Choose two.)

Question 8

(0)

The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)

Question 9

(0)

Exhibit You configured interface ge-0/070.0 to run IS-IS. but this interface does not appear in the output of the show isis adjacency command as shown in the exhibit. What is the problem in this

Question 10

(0)

Exhibit The routers shown in the exhibit ate configured for segment routing. In this scenario, what is the adjacency SIO that Router B advertises to Router A?

Open VPLUS File

Convert VPLUS to PDF

Related questions

The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)

Which two LSA types are permuted in OSPF totally stubby areas? (Choose two.)

Exhibit Referring to the exhibit, which two additional steps should you lake to fully configure NSR? (Choose two.)

Which two statements are correct about the way that BGP propagates routes by default? (Choose two.)

Which BGP attribute Is used to detect touting loops?

Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)

Which two statements are correct when using LDP? (Choose two.)

Which OSPF database packet determines which router is in charge of the database synchronization and the transferring of LSA headers between the two systems?

Exhibit Referring to the exhibit, which two statements are correct? (Choose two.)

Exhibit The exhibit shows a topology with 1 Gbps interfaces between routers, and four RSVP LSPs operating with the respective bandwidth reservations. Which path will be selected for a new LSP from R4 to R6 with a bandwidth reservation of 400 Mbps?

Question 6 - JN0-363 discussion

Report

Exhibit

Referring to the exhibit, how do you verify the status of the tunnel from R1?

A.

Issue the ping 172.20.111.10 source 172.20.110.1 command.

B.

Issue the ping 172.20.111.10 source 198.51.100.1 command.

C.

Issue the ping 172.20.iii.io source 203.0.113.2 command.

D.

Issue the ping 172.20. Ill. 10 command.

Show Answer

asked 18/09/2024

Yi-Jen Tung

36 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first