ExamGecko
Search Search Login
Home Home / Juniper / JN0-649
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Your network is multihomed to two ISPs. The BGP sessions are established; however, the ISP peers are not receiving any routes. Which two statements are correct about troubleshooting your configuration? (Choose two.)
Which address range is used for source-specific multicast?
Referring to the exhibit, traffic ingresses on interface ge-0/0/3 and egresses on interface ge-0/0/4. Which queue does traffic with the IP precedence value of 100 use?
Referring to the exhibit, which two statements are correct? (Choose two.)
BGP multipath or multihop are not configured in your network. In this scenario, what is the correct sequence for BGP active route selection?
The connection between DC1 and DC2 is routed as shown in the exhibit. In this scenario, which statement is correct?
Which three configuration parameters must match on all switches within the same MSTP region? (Choose three.)
Which three MSTP parameters must match on all switches in the same MST region? (Choose three.)
You are asked to establish interface level authentication for users connecting to your network. You must ensure that only corporate devices, identified by MAC addresses, are allowed to connect and authenticate. Authentication must be handled by a centralized server to increase scalability. Which authentication method would satisfy this requirement?
You are troubleshooting a BGP connection. Referring to the exhibit, which two statements are correct? (Choose two.)

Question 2 - JN0-649 discussion

Report
Export

Referring to the exhibit, anycast RP is implemented to ensure multicast service availability. The source is currently sending multicast traffic using group 239.1.1.1 and R3 is receiving PIM register messages, but R2 does not have active source information.

In this scenario, what are two methods to receive the active source information on R2? (Choose two.)

A.
Configure an RP set in PIM on R1, allowing R1 to forward PIM register messages to R2 and R3 in the set.
Answers
A.
Configure an RP set in PIM on R1, allowing R1 to forward PIM register messages to R2 and R3 in the set.
B.
Configure an MSDP protocol between R2 and R3.
Answers
B.
Configure an MSDP protocol between R2 and R3.
C.
Configure an RP set in PIM on R2 and R3, allowing the RPs to forward PIM register messages to the other RPs in the set.
Answers
C.
Configure an RP set in PIM on R2 and R3, allowing the RPs to forward PIM register messages to the other RPs in the set.
D.
Configure an MSDP protocol between R1 and R2.
Answers
D.
Configure an MSDP protocol between R1 and R2.
Suggested answer: A, C
Show Answer
asked 18/09/2024
Sundarrajan Mugunthan
34 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms