ExamGecko
Search Search Login
Home Home / Juniper / JN0-649
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Your network is multihomed to two ISPs. The BGP sessions are established; however, the ISP peers are not receiving any routes. Which two statements are correct about troubleshooting your configuration? (Choose two.)
Which address range is used for source-specific multicast?
Referring to the exhibit, traffic ingresses on interface ge-0/0/3 and egresses on interface ge-0/0/4. Which queue does traffic with the IP precedence value of 100 use?
Referring to the exhibit, which two statements are correct? (Choose two.)
BGP multipath or multihop are not configured in your network. In this scenario, what is the correct sequence for BGP active route selection?
The connection between DC1 and DC2 is routed as shown in the exhibit. In this scenario, which statement is correct?
Which three configuration parameters must match on all switches within the same MSTP region? (Choose three.)
Which three MSTP parameters must match on all switches in the same MST region? (Choose three.)
Your enterprise network is running BGP VPNs to support multitenancy. Some of the devices with which you peer BGP do not support the VPN NLRI. You must ensure that you do not send BGP VPN routes to the remote peer. Which two configuration steps will satisfy this requirement? (Choose two.)
You are asked to establish interface level authentication for users connecting to your network. You must ensure that only corporate devices, identified by MAC addresses, are allowed to connect and authenticate. Authentication must be handled by a centralized server to increase scalability. Which authentication method would satisfy this requirement?

Question 18 - JN0-649 discussion

Report
Export

Remote branches connect to the corporate WAN through access switches. The access switches connect to access ports on the WAN distribution switch, as shown in the exhibit. L2PT has previously been configured on the tunnel Layer 2 traffic across the WAN. You decide to move the L2PT tunnel endpoints to the access switches. When you apply the L2PT configuration to the access switches, the ports that connect the access switches to the distribution switch shut down.

Which action would solve this problem?

A.
Configure the links between the access switches and the distribution switch as a trunk port.
Answers
A.
Configure the links between the access switches and the distribution switch as a trunk port.
B.
Disable the BPDU block function on the access switches.
Answers
B.
Disable the BPDU block function on the access switches.
C.
Disable the BPDU block function on the distribution switch.
Answers
C.
Disable the BPDU block function on the distribution switch.
D.
Configure a GRE tunnel to encapsulate the L2PT traffic across the WAN.
Answers
D.
Configure a GRE tunnel to encapsulate the L2PT traffic across the WAN.
Suggested answer: A
Show Answer
asked 18/09/2024
Sushil Karki
38 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms