Home

Home / VCE / 210-010

Question list

List of questions

Question 1

(0)

Which EMC software is required to upgrade code on a Vblock System 200 storage array?

Question 2

(0)

Which two statements are correct about Vblock System Release Certification Matrix (RCM) upgrades? (Choose two.)

Question 3

(0)

Which Cisco Catalyst switch is used for network management on a Vblock System 200?

Question 4

(0)

The implementation profile located in the Logical Configuration Survey (LCS) identifies if the customer will be using which two solutions? (Choose two.)

Question 5

(0)

What are three requirements of the Vblock System test plan? (Choose three.)

Question 6

(0)

Which test is only performed on a Vblock System 320 that contains a high availability Advanced Management Pod (HA-AMP)?

Question 7

(0)

Your manager asks you to configure an external Syslog on VMware ESXi hosts. In which two ways would the Syslog be configured? (Choose two.)

Question 8

(0)

When performing hardware maintenance on a Cisco UCS B-Series blade, which GUI parameter should be selected before removing the blade out of the chassis?

Question 9

(0)

A customer notices a failed drive error for a Vblock System 320 storage array on an EMC Unisphere screen. Which logs must be collected and sent to VCE support to confirm that the drive has failed?

Question 10

(0)

Which Cisco management software is required to setup EMC e-mail home for Cisco MDS switches?

Open VPLUS File

Convert VPLUS to PDF

Related questions

When performing hardware maintenance on a Cisco UCS B-Series blade, which GUI parameter should be selected before removing the blade out of the chassis?

Which switch in the network layer provides Fibre Channel (FC) links between the Cisco fabric interconnects and the EMC VNX array in a Vblock System 320 segregated configuration?

Connectivity is required to manage the Vblock System 720 storage array in the Advanced Management Pod (AMP). Which two types of switches would be used? (Choose two.)

-- Exhibit -- -- Exhibit -- Click the Exhibit button. Referring to the exhibit, which Vblock System 320 component is "C"?

A customer would like to add a new production VLAN to their Vblock System with UIM/P. The VLAN was added to the UIM/P service profile, and the connected Cisco Nexus 5000. The customer is still not able to use the new VLAN with a virtual machine. Which step must the customer complete?

After the installing the Cisco Nexus 1000V, the administrator uses the command show svs connections. This command shows the connection status of which component?

What are three primary site survey considerations? (Choose three.)

You are adding a new VLAN from the Cisco Nexus 1000V. You use the state enabled command. What is the result of this command?

An administrator is unable to connect the Cisco Nexus 1000V to the vCenter server. The following error is displayed: {ERROR: [VMWARE-VIM] Extension key was not registered before its use.} Which action would resolve this error?

Which network capability does the Cisco Nexus 1000V provide in a Vblock System 720?

Question 106 - 210-010 discussion

Report

When powering on a Vblock System what is the correct power up sequence?

A.

Switches, AMP, SAN, UCS chassis, and UCS blades

B.

Switches, SAN, UCS chassis, UCS blades, and AMP

C.

Switches, AMP, UCS chassis, UCS blades, and SAN

D.

Switches, SAN, AMP, UCS chassis, and UCS blades

Show Answer

asked 23/09/2024

Massimo Cerqui

38 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first