Home

Home / Nutanix / NCSC-Level-1

Question list

List of questions

Question 1

(0)

During the Knowledge Transfer, the customer askes where to find the details about their Nutanix environment, such as IP addresses, storage containers, and configuration. Where can the consultant fi

Question 2

(0)

A customer is deploying Nutanix AHV clusters over hundreds of remote sites worldwide. Prism Central will be used to centrally manage all clusters. Customer security policy requires the use of MS Act

Question 3

(0)

Where can a consultant find Nutanix Enablement Starter Packs (ESPs)?

Question 4

(0)

A consultant has deployed a Nutanix cluster with AOS 5.10.x, then discovers the customer’s environment is running on AOS 5.6.x. The consultant decides to re-image the cluster using the foundation Ja

Question 5

(0)

A consultant needs to verify the make and model of the systems that will be imaged with Foundation. The consultant does not have the Bill of Materials (BOM) available to review. When should the con

Question 6

(0)

A consultant is onsite with a customer running Foundation VM (FVM) and discovers that there is no connectivity between the FVM and their laptop. The consultant verifies the following: * The consult

Question 7

(0)

Refer to the exhibit. A consultant is installing AOS 5.10 and ESXi 6.5 on three nodes. During the Foundation process, ESXi 6.5 is not available as one of the choices for hypervisor. Which soluti

Question 8

(0)

A consultant is planning an installation and needs to collect configuration items to be used during the install. The data needed from the customer are IP addresses, Gateway, DNS servers, and NTP Ser

Question 9

(0)

A consultant is deploying a Nutanix cluster at a customer location. The consultant will be deploying the latest AOS along with the latest Nutanix hardware. Which three references should the consult

Question 10

(0)

A consultant is performing a Nutanix Cluster installation on Dell XC Core hardware. The consultant decides to use Foundation Portable for Mac to perform the installation. When the consultant arrives

Open VPLUS File

Convert VPLUS to PDF

Related questions

A consultant is deploying a Nutanix cluster at a customer location. The consultant will be deploying the latest AOS along with the latest Nutanix hardware. Which three references should the consultant review prior to this installation? (Choose three.)

A consultant creates a new cluster using ESXi as the hypervisor. After creating the cluster, the consultant begins to run Life Cycle Manager (LCM) updates. During the LCM upgrade pre-checks, an error is returned. Which configuration is causing this issue?

During the Foundation imaging process, nodes are successfully imaged, but the cluster creation fails. Which log should the consultant review to determine the cause?

A consultant is using a customer’s switch for installation. Although the 10GbE ports for each of the hosts are connected to the switch, the nodes fail to be discovered. What is causing the issue?

What is the minimum number of nodes required for a Nutanix Cluster to support Replication Factor 3 (RF3) on a storage container?

A consultant creates three storage containers (container-1, container-2, container-3). The customer requires that only container-1, which will be utilized as an NFS datastore, be presented to external hosts. However, users are able to mount all three containers. What is causing this problem?

Which Nutanix feature creation is described in the Knowledge Transfer?

A consultant is onsite with a customer running Foundation VM (FVM) and discovers that there is no connectivity between the FVM and their laptop. The consultant verifies the following: * The consultant’s laptop and Nutanix nodes are plugged into a flat switch. * The laptop, switch and nodes are plugged into supported power supplies. * The laptop network adapters and FVM are configured with their corresponding IP addresses. What is the cause for the connectivity failure to the FVM?

A consultant has deployed a Nutanix cluster with AOS 5.10.x, then discovers the customer’s environment is running on AOS 5.6.x. The consultant decides to re-image the cluster using the foundation Java applet. During the Foundation discovery, all cluster nodes display a status of Unavailable. What should the consultant do to resolve the issue?

During the Knowledge Transfer, the customer askes where to find the details about their Nutanix environment, such as IP addresses, storage containers, and configuration. Where can the consultant find this information?

Question 21 - NCSC-Level-1 discussion

Report

Which Nutanix feature creation is described in the Knowledge Transfer?

A.

Calm Blueprints

B.

REST API

C.

Self Service Portal

D.

Data Protection Domain

Show Answer

asked 23/09/2024

Aung Zin

41 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first