ExamGecko
Question list
Search
Search

List of questions

Search

Related questions











Question 580 - 220-1101 discussion

Report
Export

An administrator needs to configure RAID for a video-rendering workstation at minimal cost. The solution should have high read/write performance and maximum drive storage utilization. Redundancy is not a concern. Which of the following RAID configurations should the administrator use?

A.
0
Answers
A.
0
B.
1
Answers
B.
1
C.
5
Answers
C.
5
D.
10
Answers
D.
10
Suggested answer: A

Explanation:

The administrator should use RAID 0 for a video-rendering workstation at minimal cost. RAID 0, also known as striping, is a RAID configuration that splits data evenly across two or more disks, without parity information, redundancy, or fault tolerance. RAID 0 has the following advantages and disadvantages:

High read/write performance: RAID 0 can increase the data transfer rate by using multiple disks in parallel. This can improve the speed and efficiency of video rendering, which involves processing large amounts of data. RAID 0 can also reduce the latency and seek time of the disks, as the data is distributed across multiple spindles.

Maximum drive storage utilization: RAID 0 can use the full capacity of the disks, without wasting any space for parity or mirroring. This can lower the cost and increase the storage space for the workstation. For example, if two 500 GB disks are used in RAID 0, the total capacity of the array will be 1000 GB.

No redundancy or fault tolerance: RAID 0 does not provide any protection against data loss or disk failure. If one disk fails, the entire array will fail and the data will be unrecoverable. Therefore, RAID 0 should only be used for non-critical data that is backed up elsewhere, or for temporary files that can be recreated.

Standard RAID levels - Wikipedia1

RAID Levels and Types Explained: Differences and Benefits of Each2

RAID Level Comparison Table | RAID Data Recovery Services3

asked 02/10/2024
Bruno De Brida
30 questions
User
Your answer:
0 comments
Sorted by

Leave a comment first